Question about 2008 Toyota Camry

1 Answer

2003 toyota camery

The two lights behind the fan speed button,, and the heat /cool button,, on the dashboard flickered,, then went out,, how do i replace the bulbs

Posted by on

  • BobMSKH Nov 24, 2008


    I am replacing two small
    bulbs part # 90011-11050 for the Heater, AC and Fan knobs on a 2004 Camry 4
    cyl. The 2 bulbs light the three Climate Control labels (see
    picture) not the actual knobs themselves.

    The bulbs can only be replaced from the inside rear of the
    dash, not from the front. What do I need to remove to replace them? How do I
    remove that section of the dash?

    Any suggestions are very much appreciated.


  • rll725 Dec 17, 2008

    I have a similar problem with my 1997 Toyota Landcruiser - a few of the fan directional buttons' lights have gone out on the dash. Can individual bulbs be replaced without taking the dash off? Can the buttons be removed for bulb replacement and buttons replaced? Thanks.



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Toyota Master
  • 1,861 Answers

The control panel is held in by 4 clips, one at each corner. You need a long, flat tool, preferably hard nylon, insert it at the bottom corners & pry backwards, ther clips will release, and you then pull the top towards you to release the 2 top clips. The bulbs are on the back of the control assembly. Don't use a screwdriver, it will damage the material around the panel.

Posted on Oct 14, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

2003 lincoln town car battery dash light stays on , will not start

Theres a power/ground problem somewhere in harness or instrument panel..send issue to

Nov 27, 2016 | Lincoln Cars & Trucks

1 Answer

The lights inside dashboard knobs & multi-function display went out

I'm not sure what model Toyota you have, but in a Camry, the cause is most likely a blown fuse. This is a 10A fuse labelled "Gauges" located behind a cover in the dash panel

Dec 13, 2011 | Toyota 4Runner Cars & Trucks

1 Answer

Why are the headlights and dash lights flickering?

If the warning light for your heating and cooling system is coming on, you need to take it to a good mechanic to check it out before something worse happens. if lights are just flickering, you could have an electrical problem/wiring problem. You will also need a professional to look at this in my opinion.

Nov 14, 2011 | 2003 Volkswagen Passat

1 Answer

Toyota Corolla 1995. Quality of air conditioner reduced when stopped (traffic light) or moving at slow speed (condenced city traffic) No problem on the highway. Checked freon gas and fan. Understand that...

Normal, the ac heat exchanger condenser need air moving across the fins to remove the heat. While moving in town the condenser isn't remove the meat that is building up the it's aluminum fins. Even though the vehicle uses an electric fan. The fan is used to cool the engine temperature. If you Toyota is equip-ed with automatic transmission. The electric fan will need to pull enough air to cool the engine temperature, automatic transmission fluid, air conditioner condenser, and maybe power steering condenser to cool the power steering fluid. Later model of vehicles/trucks are using different refrigerants instead R134A in which you Toyota uses.

The simples way to explain is the ac remove heat from inside your Toyota and this heat is removed by the refrigerants inside your ac in the car. To cool the refrigerant this coolant is removed to the heat exchanger condenser located in front of the engine radiator. So, while moving at 60mph there is enough air flow through the radiator, ac head condenser, and other aluminum heat exchangers. GB...stewbison

Sep 12, 2011 | 1995 Toyota Corolla

1 Answer

I have a 2003 camery le six cylender with double fans that is over heating . On the highway the temp gauge stays in the middle section but in stop and go traffic it starts to rise and the air conditioner...

stop and go traffic will make the car heat up,, make sure you have air flow through the radiator fins, also make sure that the ac fan is actually engaging the fans work on a sensor and if they don't work, neither does the fan.

Jul 22, 2011 | 2003 Toyota Camry

1 Answer

How do you reset the timing belt light on a 2003 Toyota Landcruiser?

I believe there is a button behind the dash you have to press to clear it. I have the same problem with my 1999 Cruiser but have not taken the dashboard out yet to check it. Good luck.

Jun 14, 2011 | 2004 Toyota Land Cruiser

2 Answers

I am noticing a flashing light on my dashboard. The item flashing is a car with lines coming from behind the car. it is beside d seat belt icon. What does it mean, and how can I fix it?

the symbol with a car and 2 curved lines behind means:
"Slip control" or "Stability control" (also known as ESC, ESP, ASR or DTC) warning.
Toyota Trac Inop Light Toyota's traction control helps you maintain traction on wet, icey, loose or uneven surfaces. There are complex wheel speed sensors that will trigger the traction control safety feature as needed. If you see the trac inop light illuminate, this feature might be disabled. A Toyota service rep can access the trouble code and identify what is needed to fix any potential issues. - See more at:
Toyota Dashboard Indicators

Jan 15, 2011 | 2003 Toyota Camry Solara

3 Answers

The heating and cooling fan on my 2003 Oldsmobile Bravada only runs on low speed. What do I check?Could it be a fuse?

I have an 03 bravada and the problem with my blower was the blower motor control module.I just had it replaced and everything works perfect.I paid 115.00 for the part and took 2 minutes to put in.The control module is below the glove box behind a panel.remove the panel and look up and you will see it.It has a rurple and black wire comeing off it.

Feb 21, 2010 | 2003 Oldsmobile Bravada

2 Answers

Light on a/c button flashing a/c not cooling

most like the mgt relay in the fuse box under the hood. their is a updated part from toyota.

Jul 18, 2009 | 2003 Toyota Camry

1 Answer

Toyota matrix 2003 heater heats badly and cools when engine speed drops. I suspect something in vacume control

heater heats badly and cools when engine speed drops<<<<?

Heating GOOD OR DECENT GOIN DOWN THE ROAD but not at SLOW speed or stoplight
This is useualy a sighn of low coolant,as at low speed the Flow slows downand allows any AIR Pockets to Form thus causing
Heater NOT to GET COOLLANT, SYSTEM MUST be topped off with Temperture Selector dial ON HOT And ENGINE at Operating Temp-NICE & HOT this way cooolant fills all Voids and AIR. Pockets

IF there is a Bleeder Valve at TOP of Thermostat Housing then after first Procedure, Close System with Radiator CAP then Open Bleeder SCREW let it Flow till NO AIR comes Out then Close Bleeder screw Tight.

Jan 16, 2009 | 2006 Toyota Matrix

Not finding what you are looking for?
2008 Toyota Camry Logo

752 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides