Question about 2001 Honda CR-V

2 Answers

Vibration at 2100 rpm

My Honda CR-V 2001, 2 WD, makes noise at 2100 rpm. That noise is some kind of vibration which I think comes from exhaust system. That can be heard only when the car is in "D" position, at 2100 rpm. When you put it in "N" or "P", even if you press gas pedal to 2100 rpm, there is no noise. Exhaust system has been checked completely and is ok.

Darko
Belgrade, Serbia

Posted by on

  • 2 more comments 
  • Anonymous Nov 29, 2008

    I have the same problem. My mechanic has replaced the motor mounts----did not fix it. He can figure it out.

  • dabishop460 Mar 15, 2009

    I have the same problem and nothing wrong with the motor mounts. Any chance it might be a pulley bearing or something similar. Seems to be related to light being in gear and under light torque.

  • jaden489 Mar 23, 2009

    SAME PROBLEM! I've taken it to my mechanic who can't find where it's coming from. He's checked the exhaust but can't locate it. Motor mounts are fine. It started out making the sound at 2100 rpm only between 50-60mph with my foot on the gas pedal, but now (2 weeks later) it happends at 40mph and 19mph. Please HELP!!

  • Anonymous Mar 25, 2009

    I have the same problem !!! It started then i hit 175k . I've brought it to Honda and three other mechanics no one knows that it is. And once i hit 185k the trans slips going into 2nd gear.

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Found the problem to be the gasket and bolts between the exhaust pipe and the catalytic converter that had to be replaced. It seems that over time corrosion erodes them resulting in a vibration of the heat shield at this RPM. Replaced both and the problem went away.

Posted on Jul 05, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

It is probably your Motor Mounts. They attach the engine in 4 places to the frame of the car. When the rubber wears out, it will cause excessive veibration.

Take it to your mechanic and tell him to check the motor mounts. For the front and side three mounts, it will probably run about $550 with the parts, im guessing.

Posted on Nov 22, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What's your problem? Just bought a HONDA CRV ELX 4 WD 2009 that has a growing humming noise coming, it looks like, from the tires. It grows with acceleration and ceases with deceleration. The tir


some tires howl. In some cases it is just the way the tread is made on tire....if car is not pulling and steers fine and there is no vibration than dont worry about it....wider and taller tires do it more than most...now that is if it is the tires,,,,may want to have it checked out just to be safe....good luck.......

Aug 19, 2012 | 2009 Honda CR-V EX-L

1 Answer

Hi there i have a 2003 honda civic si when ever i am sitting idle there is a rattle / clanking sound coming from under the car it is coming from the front in the center when it makes the noise and i look...


You could have a loose bolt on your exhaust manifold (this happens sometimes with Japanese cars with little reason behind it). If you can, try tightening all of the bolts on the manifold and see if that helps. If you are not very mechanically inclined and tightening the bolts does not totally resolve the issue, I recommend taking it to a mechanic -- just mention that you think it is the exhaust manifold, or the exhaust manifold seal. If the seal is worn out, you should have it replaced and that should resolve your issue.
The reason it only happens at idle is that the engine has a specific vibration to it at low RPM's ... this is a different vibration than when driving ... stepping on the gas also increases the pressure in the exhaust system, minimizing the vibrations. You should be able to get it fixed for a pretty low price, but I would recommend doing it soon so you do not allow collateral damage to the rest of your exhaust system.

May 27, 2011 | 2003 Honda Civic

1 Answer

2003 Honda CR-V when the A/c compressor kicks on the engine drops 300 rpm, like it's going to stall. It's making a clunk noise when kicking on and I changed the battery thinking it was weak.


sounds like it's the iacv or idle air control valve not working due to dirt in the orifice or the iacv is burnt out and cannot turn correctly, or the wiring to it is faulty.

Good luck on the repair.

If the A/C compressor makes a clunk noise when kicking on, that could indicate a worn out compressor.

You're right, 300 rpm is way too low. It should be closer to 600 or 700 or 800 rpm and remain smooth when the a/c compressor kicks on.

Nov 07, 2010 | 2002 Honda CR-V

1 Answer

Vibrating noise coming from rear of car between idle and low rpm as rpm increases noise goes away


this sounds like exhaust resonance. have the exhaust system checked, perhaps you may have hit something in the road.

Oct 14, 2009 | 2005 Ford Focus

2 Answers

1999 Honda CR-V rattles during acceleration


Usually it is a loose rusted exhaust heat shield or shields.
Slide under and tap the exhaust system and shields from front (on the engine )to back.......there will be at least one rattle heard.

Sep 30, 2009 | 1999 Honda CR-V

5 Answers

Vibration or rumble noise Honda Pilot


you have a bad torque converter. well documented on the Honda Pilot forum and Honda is ripping everyone off including me on the problem.

Aug 07, 2009 | 2006 Honda Pilot

1 Answer

Unusual noise


you mat want to have the lifters checked and re torqued if the car has more than 100k miles.

they tighten after time on thair own and will cause the engine to shake and feel sluggish.

Oct 13, 2008 | 1997 Honda CR-V

Not finding what you are looking for?
2001 Honda CR-V Logo

Related Topics:

362 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...