Question about 2000 Honda Accord
I'm using a S86 honda accord year 2000. The steering rack fuel keep leaking even after repaired by the mechanic. I propossed to get a second hand rack. Anyone who can help me where to find the rack. Please contact 019-9852779
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Power steering not working
The first thing you have to ask yourself is "where did the old fluid go in the first place?"
Most likely, it is leaking from the steering rack itself, and into the dust boots, which is why you can't see it.
If the system was completely empty, you will have to fill it, and turn the wheel from left to right, all the way from "lock to lock" each way. This can be hard, but that's what you have to do to get the fluid back into the system.
It "should" only take 3-4 complete turns back and forth for it to work, unless there's a major leak. Then, top off the system.
Look under the car for any signs of fluid "weeping" from out of the steering rack.
Posted on Jun 19, 2008
Should not be too hard. I have not done one on an 1986 model but I have on a 1983. The principle will be the same.
Posted on Dec 01, 2008
aside from any obvious leaks from the hoses or fittings, or the pump. typically if you were to pull the rubber dust boots of the ends of the rack, any fluid inside the boot would indicate a bad rack. hope this helps.
Posted on Dec 14, 2008
SOURCE: power steering rack leaking
If it's coming from the rack, check the rubber boots from the rack to the inner tie rods, and if they are soaked with fluid, you will need a new rack, or keep adding fluid to the pump as needed.
Hope this helps!
Posted on Dec 17, 2008
Hey, here's the procedure, disable air bag, if equipped w/ one, disconnect the pump return hose from the reservoir and place the end in a large container. Plug the port in the reservoir. Start the engine and turn the steering wheel lock to lock several times, until fluid stops running from the hose. Turn off engine immediately. Re-attach hose. Disconnect the inlet and outlet hoses at the pump. Remove the drive belt. Remove the mounting bolts/nuts and remove pump.
Install in reverse order. Adjust belt tension,fill ps reservoir and bleed any air from the system (to bleed air from system, fill reservoir, start engine and allow to idle, turn wheel from side to side all the way several times. Shut off, fill if necessary.
. Tighten bolts to : Thru bolt 30 ft lbs., mounting nut 16 ft lbs.
Posted on Dec 30, 2008
Tips for a great answer:
Jun 09, 2014 | 1999 Honda Accord
Jan 02, 2014 | 1996 Honda Accord
Jul 21, 2013 | Cars & Trucks
Dec 29, 2011 | 1998 Honda Accord
Sep 22, 2009 | 1994 Honda Accord
Dec 15, 2008 | 2006 Honda Ridgeline
May 22, 2008 | 2002 Honda Accord
Jan 07, 2017 | 2000 Honda Accord
285 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: