Question about 1995 Chrysler Concorde

1 Answer

1995 Chrysler Concorde transmission diagram

I'm leaking transmission fuild in the front of the transmission closest to the front of the car. I believe it is coming out of the front pump seal on the transmission. Need a diagram to show me where it is located so I can pull the trans out to put a new front pump seal.

Posted by on

  • alex metro
    alex metro May 11, 2010

    is the engine a 3.3L or 3.5L?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

There are 3 places it could be coming from. (1) The outer rubber seal on the pump between it and the case (2) The metal clad seal in the center of the pump that seals against the converter hub (3) And, the 5 bolts that hold the pump in have washers under them. The seal around the outside likes to get hard and brittle with age, especially if it has gotten hot before, leading to cracks that leak. The converter seal will wear naturlaly from doing it's job and more so if the pump bushing is wore out. The bolts that hold the pump in can get loose because of vibration letting oil out around the threads and out into the world.

If you pull it out and don't find loose bolts or obvious signs of a leak, then I suggest changin out all the places I mentioned. If you take the trans out and tip it on it's ****, then the pump comes out with a couple slide pullers. Be careful not to let the clutch-pack(inputshaft) slide out any, this will make going back together easier. There is a gasket between the inside of the pump and the case that will most likely need replaced too so get that as well; it seals all the ports and passages around the pump. Replace the outer square "O"-ring and the metal clad seal in the middle, then lube the outer seal and set the pump in place. Line it up and drive it in with the handle of any hammer. Torque it down(23ft. lbs.) with new washers for the bolts or new bolts with integeral washers. Be sure to loctite the threads as well to prevent them loosening up. Wiggle turn the input shaft to double check it isn't bound up and then just put it back in the car.

It sounds like a pain and it can be, but, it's easy after you do a couple thousand. Just like falling off a log. Hopefully you just have to do it once.

Posted on Nov 13, 2008

  • andyglbrt Nov 13, 2008

    Oh yeah, drain the diff lube before you do anything and you will save a lot of mess.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake line diagram for 98 chrysler concorde lxi


let it after driving, Wet spot, and leaking fluid, trace it from there, usually a failed drum brake piston, if has drums in rear

Apr 07, 2014 | 1998 Chrysler Concorde

1 Answer

How do you add transmission fluid to the torque converter on a 98 chrysler concorde?


The nine quarts is the total capacity of the transmission. The only time you would use all nine quarts is if you where flushing the transmission. You will need to drop the pan and start over as your transmission is now severly overfilled. I left the details of how to do this in your previous question. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Feb 02, 2012 | 1995 Chrysler Concorde

1 Answer

Where is the hood latch for a 1995 concorde


  • The actual latch is what keeps the hood locked down. Will look like the diagram below.


11_19_2011_2_36_49_am.jpg

  • Hope this helps.

Nov 19, 2011 | 1995 Chrysler Concorde

1 Answer

Ran fine changed battery now it wont crank or start.1995 Chrysler Concorde


I am a strong believer of the KISS therory, so lets start on the most likely. When you replaced the battery, did you also clean the battery cable connections? If not that is the most likely cause! If not, suggest you get jump your car to make sure where the problem is. If it starts with the jump start then it is in the battery system - battery, battery cables, alternator.

Aug 28, 2011 | 1995 Chrysler Concorde

1 Answer

Brake line on a 1995 Chrysler Concorde leaking brake fluid


not good , replacement part should be available , the brake system should be bleed after complete repair

Jun 27, 2010 | 1995 Chrysler Concorde

1 Answer

Does the torque converter come out of the transmission on a 1998 Chrysler Concorde?


Yes, you must remove the transmission and it pulls out the front of the transmission.

May 31, 2010 | 1998 Chrysler Concorde

1 Answer

My 2003 chrysler concorde is leaking transmission fluid. what is causing that?


All depends on where it's leaking from. If it's leaking from the transmission pan, then it's going to be a bad transmission pan gasket. If it's leaking from the transmission cooler line or connections from the transmission to the radiator, replace the line or the connections or just the O-rings in the connections. If it's leaking from the transmission housing where the engine and transmission mates, then it may be the from pump or Torque Converter. The leak could be coming from the CV joint inner shaft where it connects to the transmission. Good luck and keep am eye on your transmission oil level, low transmission fluid will cause transmission failure.

Nov 25, 2009 | 2003 Chrysler Concorde

2 Answers

How many quarts of transmission fluid does a 1995 chrysler concorde hold


That depends if you are talking about dropping the pan only - or fluid for the entire trani including the tourque converter..

If only dropping the pan - it should be about 3 to 5 quarts..

It its for the hole trani & tc - it should be 6 to 9 quarts..

Rate me good ;o)

Jul 09, 2009 | 1995 Chrysler Concorde

1 Answer

2004 chrysler sebring transmission was leaking but now has stop


Keep a close eye on the level, and watch for drops in driveway etc. Even try placing something under the transmission area if you have to, like cardboard or plywood. Good chance it didn't cure itself, but stranger things have happened I guess. Hope you used Mopar transmission oil to re-fill it. believe it or not, I don't work for Chrysler but have heard many a story about chrysler transmissions acting up because of wrong fluid in them, even when lube places tell you it's o.k to use something else. Just a heads up.

Dec 11, 2008 | 2004 Chrysler Sebring

Not finding what you are looking for?
1995 Chrysler Concorde Logo

432 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...