Pc valve where is the pc valve on a 1992 buick century 3.3 Liter engine

Go to You Tube Video & watch

Open the Century's hood. Follow the upper radiator hose from the engine to the coolant outlet housing, on the upper portion of the engine's side.Remove the bolts holding the coolant outlet housing to the engine, using a socket wrench and an 8 mm socket.Pull the coolant outlet housing off the engine, by hand. Shove a rag into the outlet housing to prevent debris from entering the engine.Clean the sealing surface on the engine and housing, using a gasket scraper.Remove the rags from the engine and coolant outlet housing. Start the engine and let it run until the temperature gauge reaches operating temperature.
Buick Parts

you want to flush out the trani most likly is the filter ran through the trani the check balls inthe shift siloniods are clogged with filter now, but if you have low/1 and reverse the other possibility is that you lost a clutch band inthe trani, that would require a new trani.

For 1999 Buick Century 3.1 liter V-6 VIN "M" check...




Hope this helps (remember to rate this answer).

1994 Buick Century 2.2 liter L4 VIN "4"




1994 Buick Century 3.1 liter V-6 VIN "M"



Hope this helps (remember rated and comment this).

1992 Buick Century 3.3 liter V-6 VIN "N"




1992 Buick Century 2.5 liter L4 VIN "R"



Hope helps (remember rated and comment this).

1-5-3-6-2-4

1992 Buick Century 3.3 liter V-6 VIN "N"



Hope helps (remember rated this).

Depends on what engine is in each of the vehicles. Assuming that the 1992 Park Avenue and 1995 Buick Century both had similiar engines (both being a V6), then they would both be equiped with the 4T60E transmission and you should have no problems interchanging them. Any differences (if any) in the wiring or valvebodies can easily be changed from one to the other and will be fairly self-explanatory.

Hope this helps and good luck!