Question about 1995 Buick Century

1 Answer

Power window My driverside power window is stuck about 1/2 way down. how can I get it to go up if the motor is stuck

Posted by on

  • Zachary Hales Oct 13, 2008

    I know the switch needs to be replaced. but I want to get the window to come up until I can get it replaced.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

You need to replace the power swith.

Posted on Oct 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i repair the wiring to the other windows in my 2001 Buick Lesabre Custom? Only my driverside window and power lock works


FIRST MAKE SURE YOU DID NOT LOCK THE WINDOW, BY RELEASING THE BUTTON, THEN REMOVE DOOR PANEL ON PASSENGER SIDE , UNPLUG WINDOW MOTOR, AND TEST FOR POWER AND GROUND AS SOME ONE PUTS THE WINDOW DOWN FROM BOTH SWITCHES, IF POWER AND GROUND IS THERE REPLACE MOTOR, IF NO POWER THERE CHECK SWITCH, POSIBLE BAD SWITCH, BUT IF YOU SUSPECT WIRING , CHECK THE DOOR JUMB ON DRIVERS SIDE, INSIDE THE RUBBER BOOT MAY BE ONE OR MORE BROKEN WIRES , REPAIR THEM. NORMAL

May 08, 2014 | Cars & Trucks

1 Answer

The driverside window on 2008 nissan altima is not working


see the diagram and troubleshooting. God bless you

see for dirty, corrosion, oxide, bad contact, loose connector, switch faulty or dirty or bad contacts, motor faulty, LUBE in the system.

10_18_2012_5_35_16_am.gif

Oct 18, 2012 | Cars & Trucks

1 Answer

My 2002 Chevy Tahoe's driverside window won't go back up there is power to the window switch it makes a clicking sound so is it a motor or a regulator


You will need to remove the door panel and check that all the linkage is in the proper place and snugged down. The gears from the motor to the window mechanism may be stripped or not making proper contact. The motor may also be bad as it takes more power to roll the window up than down. Please rate this answer, thanks.

Feb 05, 2011 | 2002 Chevrolet Tahoe

1 Answer

Window stuck midway down on driver side driver switch control not working........how do i get to it to fix switch or motor or whatever may be the problem??


first remove door pannel and switch use test light at motor leave motor connected use a pin in oneterminal so you can attach test light ground end to pin place pointed end into other terminal doesnt matter which terminal basically place test licht in paralell use window switch testlight will light up if switch is ok and motor is deffective if no power to test light main switch on driverside is deffective

Jan 13, 2011 | 2002 Jeep Grand Cherokee

1 Answer

Passenger window on my 2001 chrysler sebring sedan will not go up or down. What could it be and does each window have a seperate fuse? Thank you


Have you had your windows down in a rain storm, ecspecially the driverside,if so you may need to replace the window controls on the driverside.One fuse should operate all window motors.if the fuse is good then it may be the motor on the passenger side went out and may just need replaced.

Jan 09, 2011 | 2001 Chrysler Sebring

2 Answers

First the driverside window would not go down . then it went down, and wont go up.


a plastic safety gear that protects against closing injuries is broke inside the window motor-thats common -someone may hav stuck something inside window and caused it to break

Apr 26, 2010 | 2000 Chevrolet Blazer

1 Answer

Driverside power window went down and will not roll up


The window motor probably quit working. Try banging on the inside of the door near the bottom, at the same time holding the switch to raise the window. Sometimes this will give the motor one more chance at raising the window.

Feb 22, 2010 | 2004 Pontiac Montana

1 Answer

Front driverside power window


Remove the door panel, locate power window motor and unplug. With a test light or meter, check for voltage at the plug while pushing window switch. You will see voltage at one wire to ground for up and the other wire to ground for down. If you have voltage at the plug, replace motor. If no voltage, check switch and wiring. Switch is probable cause for no voltage at motor plug.

May 27, 2009 | 2006 Dodge Stratus

1 Answer

I need to replace the driverside power window motor on 1986 Ford


if i remember correctly it comes as a assembly with the regulator fabricated on to it. just a thought you can usually find a salvage yard to get assmbly for around 25. to 35. bucks cash and carry.
also alot of these yards have their own glassmen that can install for u at additional cost. if you would like.

hope 2 help shack

Apr 05, 2009 | 1986 Ford Econoline

1 Answer

Non Working driverside power window 86 GMC


sounds like you need a window regulator to me check napa or a good parts store

Mar 19, 2009 | 1986 GMC G3500

Not finding what you are looking for?
1995 Buick Century Logo

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...