Question about 2000 Ford Expedition

1 Answer

2000 Expedition keeps dying

It will start then dies. I hear a vibrating buz from the right side of the engine. Could this be the oxygen sensor?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 350 Answers

Hi the oxygen sensor only kicks in when engines hot not on a cold engine what you need to do is get some one to find the buzzing noise then get back with some sort of discription yates210456

Posted on Oct 12, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Recently bout three months my engine oil light


When an engine oil light comes on, this is the 911 call to you that your engine is having an emergency in that there is not enough oil to lubricate the moving parts of the motor that keep it operating. Those knocking noises that you heard were the dying breath of your once dependable Ford engine; which is now junk. Because you "didn't have the time to pick up oil", you will now have to find the time to either replace or completely rebuild the engine. The Expedition has a V-8 so expect to pay at least $3500 for a new motor.

Oct 06, 2014 | 2000 Ford Expedition

2 Answers

EXPEDITION STARTS UP FINE BUT DIES SOMETIME WAIT IT RESTARTS


There is a cold start "sequence" which is suppose to reset the engine controls as if you had a choke. This sequence is triggered by water temperature sensors on the engine.

This sensor is different from the one operating the dash gauge. It is probably stuck on a "hot" setting and the engine controls do not reset.

Oct 16, 2013 | 2000 Ford Expedition

1 Answer

My 2001 ford expedition won't keep runing when it's cold I have to keep my foot on the gas or it dies until the engine warms up. What is going on?


Your vehicle needs a signal from a Temperature sensor to activate the "Cold start routine". The cold start routine is a modern day version of a choke used in the old days. This process will make the engine speed up by enriching the fuel mix and resetting the engine timing.

The problem is that your engine is stuck in the normal "Lean" run position for better mileage and lower emissions. There can be 2 temperature sensors in each vehicle with only one dedicated to operating the engine controls. The other sensor would operate the dash gauge or light.

When the Temperature sensor is replaced, the system should work again. If it does not respond, there could be a connector problem in the PCM unit, but it is less likely.

The onboard diagnostics would generally monitor the PCM, but the Temperature sensor is usually an unmonitored device.

Please rate my info.

Jan 10, 2013 | 2000 Ford Expedition

1 Answer

My Kia Sephis keeps dying and wont start sometimes


That Engine fuse you are replacing is the engine fuse,The nearest ground that can short that out is the oxygen heater circuit of the catalytic convertor,it may be the oxygen sensor itself,but more than likely its the harness you will have to open the harness and inspect for a rub through wire

Mar 15, 2012 | 1996 Kia Sephia

2 Answers

2000 Toyota Camry When the engine is cold and the car is started, the car engine usually vibrates ans shakes. I changed the plug and the problem stopped, but after a few weeks the problem started again. ...


Hello and welcome to FixYa!

Looks like that you have a bad O2 sensor. If the O2 sensor is faulty the car may shake and there's noticeable bad emission odor. I strongly suggest that you have it replaced. You can find this sensor on the exhaust manifold.

Do you have an erratic idle? If you do then the MAF sensor must be replaced as well. A bad idle can cause the vehicle to shake. Keep me posted regarding the progress.

Hope this helps and thank you for using FixYa! Have a good one!

May 11, 2011 | 2000 Toyota Camry

1 Answer

Engine hestitation, 2000 subaru forester


I think these codes are indicating a fault with your catalytic converter. The 02 sensors are each not returning the correct values to the ECM, causing a "suspect the 02 sensors" fault code.

Apr 01, 2010 | 2000 Subaru Forester

1 Answer

I have a 2000 ford expedition w/ 4.6 l, engine will start but will not idle.I have to press on gas pedal to keep engine from dying also seems to be surging at 500 rpm.there is no misfire and runs smoothely...


The TPS sensor (or Throttle Position Sensor) is bad locate it and replace, it is located where the rubber air intake hose meets the intake manual, look for a wireand plug, also to make sure it is this sensor bring the truck to an Auto Zone and have them read any stored trouble codes for free this should confirm the faulty TPS.

Oct 12, 2009 | 2000 Ford Expedition

2 Answers

98 expedition starts then after 15-20 seconds engine dies..


Replace the idle air control valve. Mine just did it today the 15th of August. I replace the Idle air control valve and problem solve. I have a 2000 Expedition 5.4 liter.

Mar 29, 2009 | 1998 Ford Expedition

Not finding what you are looking for?
2000 Ford Expedition Logo

215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...