- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
DEAR. MADAM AND SIR. I HAVE A 2001 NEON. IONE DAY I WAS COMEING HOME. ON TORMBAM ROAD THE RAD HAD A SMALLO LEAK AND ENGINE GOT WET. THEN THE TANS. FLUID WHENT IN THE COOLANT. THEN THE TRAN FLUID GONE THEN I TRY TO FILL IT UP TRANS. FLUID. I TOOK IT TO MY MECHANIC PUT NEW RAT AND FILL TANS, FLUID THEN PUT COOLANT IN THE RAD IT STARTS GT DRIVE I G AND 2 G REVERSE DID WANT TO GO BUT IT
P0732 Gear 2 Incorrect Ratio P0720 Output Speed Sensor CKT Malfunction P0736 Reverse Incorrect Ratio P0500 Vehicle Speed Sensor Malfunction P0700 Trans Crt l System Malfunction P0731 Gear I Incorrect Ratio
Sounds like it could be worn gear linkages, which would stop you from being able to push the gearstick in to the reverse gate (usually by pushing the gear stick down or pulling a lever up under it). If you can get under the car take a look, there should be a set of joined poles leading out from where your gear lever is, check that all the connections on these are reasonably tight.
Sounds like the ignition cylinder is jambed, if you remove the covers and put the key in, you might be able to turn it with pliers, just turn it to the accessories position, then there is a small metal clip that pushes in, push it in and pull the lock cylinder out of place, get a new one from the dealer and reverse to install. If it's above you, your dealer can help, usually about an hours labour or so.
Hope that helps, Good luck
Do you have an aftermarket stereo installed? Well, try this. Remove the ground cable from the battery. Install a new fuse. if it continues, Remove the center console. and check the reverse wire connected to the shifter. It did the same thing to me and all it was, was that wire was touching other wires