Question about 2003 GMC Sierra 1500

1 Answer

Intrument cluster how do you replaced lights for gauges

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 341 Answers

If you pull on the trim around dash it will pop of. take ouy 4 screws holding cluster lift out .

Posted on Oct 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2002 f 250 7.3 no instruments gauges work disconnected bowl heater replaced ignition fuse turn key on blows fuse again what can it be


Inspect harness wirin for damage. Somethins causing resistenc or short. Bad ground is comon too. Cud hav worn intrument cluster or reconnect heatr

Jun 30, 2015 | Cars & Trucks

1 Answer

Intrument cluster


If all gauges cut off, its is likely a power supply problem not the cluster. Try wiggling the rear connector, unplug and re-plug to "wipe" the connections.

Jan 26, 2014 | 1995 Eagle Vision

1 Answer

I have a 99 Chevy Silverado 1500 my RPM gauge stopped working but runs fine how can this be fixed?


replace all gauge motors ( stepper motors) in the intrument cluster . google shops in your area that will just change the motors . many people will do it for around 100$

Sep 21, 2013 | Cars & Trucks

2 Answers

Fuel gage reads empty all the time put on new sending unit that did not help


BAD INTRUMENT CLUSTER HAVE SEEN IT PLENTY ON GM CLUSTERS TRUCKS CARS ALL THE NEEDLES GO WACKY.YOU CAN LOOK ON EBAY THEY HAVE REPAIR PEOPLE FOR 70 BUCKS THAT WILL TOTALLY GO THROUGH THE CLUSTER AND PUT ALL NEW BULBS IN IT.AND YOU CAN DRIVE IT WITH NO CLUSTER IN IT WHILE YOU GET IT FIXED .ITS A PAIN BUT CAN BE DONE.

Aug 05, 2011 | 2005 Chevrolet Trailblazer Ext

1 Answer

Every time my husband starts his 01 mustang all of the gauges go all the way to the right side. its like the battery is reseting each time.


on a ford that is very common its called a gauge sweep its to prove out the intrument cluster to make sure everything is working... Its a self test the cluster does on its own to make sure all gauges are operational and make sure they will do there full travel... Its a normal characteristic and there is no flaw with the system and no recommendation on repair

Dec 14, 2010 | Ford Mustang Cars & Trucks

1 Answer

Intermitten electrical problem with the instrument panel


look like shorted out cluster (intrument panel) get a second hand one its cheaper or body control module when it does the car dont start or goes good if it doesnt start bcm if it run bad cluster good luck pierre

Jul 31, 2009 | 1998 Pontiac Grand Am

1 Answer

1999 Jeep Wrangler Dashboard


A poor connection at the self docking connections of the cluster. Remove the trim across the top of the intrument panel. Remove the screws at the top of the cluster trim and remove the trim. Remove the cluster screws and cluster. Apply dielectric grease to the self docking connectors of the cluster and reinstall. This should take care of it.

Apr 28, 2009 | 1999 Jeep Wrangler

1 Answer

2003 F350 Intrument Cluster


If everything keeps going like that then it sounds like its a problem with the onboard computer. The computer controls all the guages and would explain why they all fail at the same time.

Sep 25, 2008 | 2002 Ford F250 Super Duty SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...