Question about 1995 GMC Safari

2 Answers

Fuel system i put new fuel pump on and tune up but it still won't start.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Try replacing the Fuel Pump Relay.

Posted on Nov 08, 2008


  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 182 Answers

Change the fuel filter and check to see if you are getting spark to the sparkplugs

Posted on Oct 12, 2008

6 Suggested Answers

SOURCE: 1997 GMC K1500 4x4 5.7 ex.cab SFI injection system

Did you check the fuel filter?
or possably the catalitic converter is cloged, check the exhaust pressure.

Posted on May 27, 2008

toyo Man
  • 6 Answers

SOURCE: 1995 jeep cherokee sport

check for cloged fuel filter and check for clogged fuel injectors

Posted on Jun 21, 2008

Mike258
  • 1498 Answers

SOURCE: 1997 GMC K1500 4x4 5.7 ex.cab SFI injection system

Hey there boatright33,

A few things things immediately come to mind.

There may be a problem with the engine controller. You could check the ODBII onboard diagnostics. Auto part stores will usually do this for you at no cost.

When you pulled the ones that were/went bad, how did the filters look? Could there be particulate matter still in the tank causing them to fail.

I always put this one off until last. Check the injectors. Are they gummed up?

Let me know what you find out
Mike


Posted on Aug 12, 2008

  • 5 Answers

SOURCE: 2002 kia sedona won;t run

Kia have somewhere announced technical fault and are well aware of it something to do with an 'evaporator and that fact that your coolant temp is being misread at 45 degrees or something'. This is a recent discovery and so you may need to contact Kia, your local dealership may proabably be unaware. Check out the forums type in Kia problems into google and look for your problem.

Posted on Dec 10, 2008

kollak81
  • 11 Answers

SOURCE: i put a new fuel pump in and still wont start

ok if the fuel pump is energizing and you can hear it turn on then the pump is working fine and you probably have a restriction. i would replace the fuel filter. when you replace the pump did you replace the strainer on the pump? if not then thats where your problem lies. also could be the fuel pressure regulator also. there is a schrader port on the fuel rail try taking a pen and press down on the core to see if fuel squirts out. or connect a fuel pressure guage to the port and see if you have the right fuel pressure. it should run between 35 and 47 psi

Posted on Aug 09, 2009

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

87 chevy wont start


seems fuel related--pump and pressure regulator may be failing--a pressure test for residual fuel is needed. Go to an honest, independent or specialist. Injector driver could be going bad. It\'s in the computer. Get a obd 1 scan tool on it to read data as well as any codes

Jun 30, 2013 | Cars & Trucks

1 Answer

Vp commodore won't start


starter,coils ,tune up,fuel filter,

Mar 07, 2013 | Cars & Trucks

1 Answer

My 2004 chevy venture won't start. Changed the


Did the fuel pump come on?

Did you check fuel pressure at the motor?


Try jumping the relay to get pump on?

Read a wiring diagram-- so you know what your doing?

Check Power & Grounds to pump when the tank was down?

Dec 22, 2012 | Cars & Trucks

1 Answer

Changed fuel pump and still won't start


Have you checked the fuel pressure at the injector ? It has to be at least 60psi for the engine to start.

Dec 08, 2012 | 1999 GMC Jimmy

1 Answer

2002 ford taurus won't start - brand new battery and complete tune up still won't start


Sounds like your not getting any fuel..Listen for the fuel pump,by removing gas cap and put your ear up to it..cycle the key without starting it and listen for the pump..sometimes you can beat on the bottom of the tank and it will jarr the pump and it will start running again..Not a fix but a conformation

Sep 08, 2011 | 2002 Ford Taurus

1 Answer

Dear Fixya, My 1993 excel hyundai turns over but won't start, we put plugs and wires and new fuel gasket. we r wondering where the fuel pump is, is there one or two pumps and how to get to them to fix...


Have you checked for spark first? Sometimes a car won't start due to no spark. This condition is usually caused by: Security system, bad ignition module, crankshaft sensor, camshaft sensor. You check it by pulling a plug wire and putting a screwdriver in the wire to see if it arcs. If it is getting fire look for the fuel pressure release valve usually located on the fuel rail, looks like a tire valve stem. If it shoots out gas, and you hear the fuel pump prime, check the fuel pressure regulator. It could also be the timing. There are four things needed for a car to start: fuel, spark, timing, compression. As for your question, as far as I know there is one fuel pump, you have to drop the tank to fix it. Hope this helps.

Jun 10, 2011 | 1994 Hyundai Excel

2 Answers

Turns over but won't fire the motor.Getting gas,new coil,new distributer,still won,t fire.o


Did you do a tune up on the vechicle? Does it sound like it wants to start? It could be the spark plugs.

Nov 27, 2010 | 1993 GMC Sierra

3 Answers

1997 GMC K1500 4x4 5.7 ex.cab SFI injection system


fuel pump died replaced it truck ran poorly afterwards. Had a prussuer test done pump determend pump was no good. Put in another ran good for 2 days started running poorly hard to start no power. 2nd fuel pump. So i figure another bad new fuel pump wow changed it put in a third brand new fuel pump. Still will not eve start now. I had it tuned up 2 months ago new plugs rotor, cap, etc. put in a new fuel filter made sure it is on proper checked all connections for leaks. this cannot be a fuel pump problem now. no problem with the elctrical i figure i have great spark on ignition tester. I can hear the fuel pump prime when i turn the key. but when i went and checked the fuel port i had no pressure. When it is being cranked gas sews out of the test port. Also i dont if this is comon cause i used to turn my keyand go. but when i have someone turn the key and i listen at the gas tank whn the key is shut off i hear gs spraying back into the gas tank. So i am open for opinions.

May 18, 2008 | 1993 GMC Sierra K1500

Not finding what you are looking for?
1995 GMC Safari Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...