Question about 2006 Chevrolet Equinox

2 Answers

2006 Chevy Equinox--

Can someone please tell me how to get to the license plate bulb to replace it? There's nothing in the manual that even mentions bulb replacement for the license plate.

Thanks.

Posted by on

  • Anonymous Mar 17, 2014

    speedometer bulb how to replace 2006 equinox

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

There are two screws in each lens. Remove those screws and carefully pry the lens off. I did it recently. It worked well for me

Posted on Dec 08, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 958 Answers

Normally, these small bulbs are just pushed in in the housing but you need to open the lens cover to replace it. if it has screws, remove first the screws. if no screws, pry them carefully.


tnx 4 using fixya,

drcool

Posted on Oct 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 chevy equinox license plate light won't work after bulb and fuse replacement


Do the park lamps work ? license plate lights get power from same fuse ! Check ground wire ! use a volt meter an do voltage drop test ! Voltage Drop Testing The fuse for the license plate lights is in the under hood fuse box -engine compartment ! fuse #12 RT PRK LAMP 10Amp .

May 23, 2015 | 2007 Chevrolet Chevrolet Equinox LT

1 Answer

2004 malibu. i have replaced license plate bulbs but they are still not working. can someone please tell me where their fuse is?


Sorry to say the license plate lights get power from the same circuit the parking lights do. So if the parking lights work, the license plate lights should have power too.

Jul 29, 2014 | 2004 Chevrolet Malibu

1 Answer

How do I replace the license plate lights?


I have a 2008 Equinox and it was a hassle to do on mine. The manual talks about removing 2 screws from the outside to remove the cover on each bulb. I was unable to get the old bulbs out. I then removed the plastic molding from the inside and the light sockets twist and pull out. The bulbs are easy to remove and replace then. The plastic panel inside just snaps out at several places. I had to loosen the back wiper motor
to get to one of them.

Feb 08, 2014 | 2006 Chevrolet Equinox

1 Answer

I need to know how to replace the license plate bulb on a scion xa


Email Chris Bacon here: www.autolumination.com
*License Plate Light Bulb Size: 168
I buy all of my bulbs there.

Sep 09, 2012 | 2006 Scion xA

1 Answer

2008 equinox license plate lamps


on a 2008 chevy equinox how do you replace the license plate light bulbs

Jan 29, 2012 | 2008 Chevrolet Equinox

1 Answer

Replace license plate bulb.


You need to pull the cover of the bulb off, There may be a clip it may need help from a screwdriver. Replace the bulb and replace the cover

Jul 05, 2010 | 1999 Chevrolet Silverado 1500

3 Answers

2006 chevy equinox, when i try to turn on my car it sometimes takes awhile to turn over. auto zone diagnostic recognized a rich or leancondition on one engine bank. suggested to check/change mass air...


sombody ripped you off i am fifteen and can tell you none of the auto zone **** is true exept the fuel injection or ignition misfire then again what does autozone know go to a chevy dealership and ask them shoot it might even be the carborater

Dec 02, 2009 | 2006 Chevrolet Equinox

1 Answer

Access to license plate bulb is difficult


Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle... You'll need a small screwdriver

Sep 30, 2009 | 2006 Hyundai Sonata

2 Answers

How do I change the lights above the rear license plate?


You just need to push the lights to one side, either towards the left or the right as they're held in by a metal clip that will pop out once you push it far enough over

Aug 17, 2009 | 2005 Chevrolet Equinox

1 Answer

I'm trying to replace the rear license plate bulbs on my 2005 chevy equinox. Anyone with any knowledge on this for me would be greatly appreciated.


sometimes the bulb lens has two screws if not pull rear door or gate panel and bingo right there in the center panel twist plug and pull.

Jun 29, 2009 | 2005 Chevrolet Equinox

Not finding what you are looking for?
Cars & Trucks Logo

437 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...