Question about 1995 Jeep Grand Cherokee

1 Answer

95 cherokee engine cuts in and out after using passing gear

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Expert
  • 475 Answers

Is it stalling? If so, does it restart right away? Possible crank sensor.

Posted on Nov 20, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Transmissions reverse ànd high gear 95jeep grand cherokee

I can't decode that. the ZJ jeep 95
check levels yet?, the correct way ,not using engine oil check way>?!
the A/t is a very complex system. with electronic controls(not all)
its seems simple to a driver but is not, in truth. not at all.
and we'd need full set of symptoms, good and bad, or ugly
to guess. (wildly) both parked tests, and driving tests...

what do reverse or high not do. does wrong, name it?
does transmission, work hot cold or fail both modes.
1: does the transmission pass the stall tests. parked. hot and cold
as stated in the SM, service man.
does the stall test slip?>
if yes, this is all we need. just the parked car stall tests
if it passes that tests in Drive and REV>
then it must be a driving test , it fails only when driven at speed
so does it fail to shift all gears.
does it FLARE between gears (slips or has what is called false neutrals)
does it skip gears, 1,3,4,? like that
does it fail only up shifting or down or both.
all those complex symptoms are in the SM
the 42/44RE box.
chapter21 , RTM.
read this page .19 , chapter 21
seen here, posted 300 + times now, and 100% free and real.
the real book by jeep, no clones no bs
click ZJ

page 15 is stall test, that any one can do... is done of the level checks.

Nov 30, 2016 | 1995 Jeep Grand Cherokee

2 Answers

My truck is a 95 chevy silverado 1500 it cuts off in 1st gear

Does it seem like when the engine is cold it runs ok, then when it reaches operating temp. it starts acting up? (poor acceleration, stalling) When I had that problem w/ my 93 K1500, it ended up being my oxygen sensor. (causing too rich of a mixture in the throttle body)
Hope this helps, Good luck

Mar 19, 2014 | 1993 Chevrolet K1500

1 Answer

Car misfires in passing gear

Are you sure you mean passing gear ?
Or when it shifts into overdrive ?
Passing gear would be when it downshifts from 3rd into second gear.
If the car is OBD2 the check engine light should be on if the miss is steady. If the light is on you can have the computer scanned to find out which cylinder is failing.

Apr 04, 2013 | 1996 Buick Park Avenue

1 Answer

Stops running when put in gear

i just had same problem. It was the crank sensor. Cost $95 for part

Feb 10, 2013 | 1996 Jeep Grand Cherokee

2 Answers

01 Jeep grand cherokee laredo won't start. No fire is going to engine. Changed spark plugs but didn't help at all

you might want to check you cam shaft sensor amd also there is a different sensor under the distutor i had to replace both of these on my 95 jeep grand cherokee laredo

Dec 04, 2010 | 2001 Jeep Grand Cherokee

1 Answer

Just put another tranny in my 95 jeep grand cherokee now it wont shift out of 3rd gear what could be the problem 4.0 engine automatic

it could be a few different things? try un-plugging and plugging back in your wire connector to the transmission control module,or replace the tranny filter

Aug 09, 2010 | 1995 Jeep Grand Cherokee

1 Answer

95 jeep grand cherokee starts up fine but when i put it in any gear exceot nueltruel shuts off

sounds like it is starving for fuel. check or repace fuel filter. when load is on engine, it needs the proper fuel to injectors. check fuel filter.

Jan 27, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Torque spec for ring and pinion gear (RING BOLTS) 1997 wrangler TJ

Ring Gear Bolts

Models 181, 186 & 194 Axle 70-90 (95-122)
Model 198 Axle 95-105 (129-142)
Models 216 & 226 Axle 80 (108)
8 1/4" Ring Gear (Cherokee) 70 (95)

Oct 12, 2009 | 1997 Jeep Wrangler

1 Answer

My 95 grand cherokee starts fine but isnt charging

Pretty sure the regulator on those is in the computer (I know...really dumb...) There is a way to wire around it using an older style regulator but it will keep the check engine light on and may not pass inspection like that.

Jul 07, 2009 | 1995 Jeep Grand Cherokee

1 Answer

What other yrear transmissions will fit in the 95 grand cherokee with the 6cyl besides 95?

42RE: The 42RE four speed automatic transmission was used in 1993.3 to 1998 Jeep Grand Cherokees with 4.0L engines. 46RH: The 46RH four speed automatic transmission was used in 1993 to 1995 Jeep Grand Cherokees with 5.2L engines.

May 29, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides