Question about 2002 Chevrolet TrailBlazer

1 Answer

Igniton wiring schematics

I need the ignition wiring schematics for a 2002 trailblazer

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 514 Answers

For a full list and pics of the ignition for your vehicle, go here:

Posted on Jan 15, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How to remove a instrument cluster on a 2002 chevy trailblazer lt

It's been a while since I did one. First check the fuse. The n remove the knee bolster, Couple of screws at the bottom and pops of at the top. Remove the bezel screws under it. Look at the cluster, Could be 2 or 3 screws holding it the bezel there. Te bezel pretty much pops off from there. If it seems tight around the ash tray, pull the ash tray. There are 2 screws there. You have to have the key in the on position and pull down the column shifter to get the bezel out. There are 4 screws to remove the cluster. Unplug it and plug it back in, see if it starts working. If not, then you need to do some wire chasing. You'll need wiring schematics and pinouts for plugs. You could just replace the cluster. But I have never had to. Usually wiring/plugs. Once I replace a PCM.

Mar 08, 2016 | 2002 Chevrolet TrailBlazer

1 Answer

I have a 2002 Chevy Trailblazer LTZ that has climate control and it just suddenly after getting fuel the drivers side air condition is working but the passenger side is full heat and cannot get it to

There is an actuator on that side. Pull the plug and put it back in, see if it works. If not, then you will need a wiring schematic to check for power and ground. If both are there, replace the actuator.

Oct 01, 2014 | 2002 Chevrolet TrailBlazer

1 Answer

Engine wire harness diagram for 2002 lancer oz rally

I am really impressed in your blog.....and Thank you for sharing this information...It is Very interesting..<a href=""> Trailblazer SS parts</a>

Nov 11, 2013 | 2002 Mitsubishi Lancer

1 Answer

Engine schematics for 2002 trailblazer 4.2 ltr.

The 2002 Chevrolet TrailBlazer comes standard with a 4.2-liter inline six-cylinder engine. ---------------------------------------------------------------------------------------
Launch CResetter Oil Lamp Reset Tool

Mar 07, 2013 | Cars & Trucks

1 Answer

Car continuously turns over when replacing the ignition in my 2002 grand am

it is out of adjustment. just take it out and redo it .

Dec 21, 2012 | Cars & Trucks

1 Answer

How do i bypass the igniton

If your looking for someone to tell you how to hot wire a car, your not going to get much help here. If you need information on replacing the ignition switch, or disabling the ignition before cranking the engine over for servicing then you've come to the right place.

Aug 28, 2009 | 1983 Subaru Gl Wagon

1 Answer

No power and key cannot be removed

Your are correct. The ignition switch has tumblers inside and are not releasing . You need to take the vehicle in to have the igniton switch replaced. Then you should be okay .

Jul 18, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

I need schematic for rear brakes for 2002 Chevy Trailblazer

haynes manual has photos to show you how to work on rear brakes.

Jul 03, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

2002 villager

It is connector c146B, 2 pin connector. there is a geen wire that provides the igniton tach signal. The other brown wire provides voltage from the ignition switch.

Oct 19, 2008 | 2002 Mercury Villager

Not finding what you are looking for?
2002 Chevrolet TrailBlazer Logo

Related Topics:

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides