An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: Tail light out
The Are Accessed From The Inside Remove The Carpet And Or Panel Directly Behind The Light On The Inside And You Will See The Light Assembly. Once You Find It Turn Counter Clockwise To Remove And Clockwise To Reinsert. Sincerely, Michael Scott
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
How Do You Change Tail Light Bulb Remove the wiring harness from the tail light lens assembly. Disconnect tail light bulb from the wiring harness socket. Reconnect the wiring harness to the tail light lens assembly. To confirm proper installation of the new tail light bulb, place the key in the on position. IT IS VERY SIMPLE OR GO TO AUTOZONE AND HAVE THEM CHANGE IT OUT FOR YOU AND WATCH THEM ONCE. GOOD LUCK.
does the high mounted brake light work? the brake switch has 2 contacts one for the high mount (LT BLUE/BLACK) and one for the tail brake lights. The tail/brake light wire is LIGHT BLUE. the main connector between the brake light switch and the tail lights is C208 which is located behind the rear seat, left side. So if there is power coming out of the brake switch OK and no power at the tail lights, check that connector. Hope this helps.
Access to the tail light cluster should be through panels in the rear corners of the vehicle. Remove the panel and you can remove the tail light cluster to replace the bulbs. This is the position on most sedans, unless, like on pick-ups, the tail light lenses have screws which allow the lenses to be removed to change the bulbs.
process for replacing tail light bulbs is the same in all models. If
you have a burnt-out tail light bulb, you may need to replace the
brake light, the reverse light or the turn signal. The procedure to
replace each of the bulbs is the same.
Open the Hummer's rear swing gate. This will expose the edge of the
vehicle's tail light assembly. You'll see two small Phillips head
screws that hold the tail light assembly in place. Put on your
Remove the two screws from the tail light assembly. Pull the tail
light out and inspect the back for two bulbs. The top bulb is the
brake light and turn signal. The bottom bulb is the reverse bulb.
Determine which bulb you need to replace.
the bulb's socket counterclockwise to disconnect it. Unplug the bulb
from its socket.
the replacement bulb into its socket firmly. Insert the socket back
into the tail light. Turn it clockwise to secure it in place.
the tail light into its cradle. Hold it with one hand and replace
the Phillips head screws with the other.
The tail-light must then be carefully pulled/slid outwards. Notice how
the end of the tail-light . Remove the
two plugs attached to the tail-light using the needle nose pliers and
place the tail-lights in a safe place.
Open rear hatch. Remove two mounting screws at the side corner which mount the tail light assy to the body. The whole tail light assy can now be removed. Twist desired bulb holder counterclock wise to remove, then pull bulb to remove. Reinstall in reverse order.