Question about 1990 Acura Integra Hatchback

2 Answers

Car will just turn over no spark, i replaced the distributor, ecm, battery, but can't find the main relay would that cause the problem 90 integra have no spark and fuel, and check engine light not on when turn key on II. here all things I check and change: change main relay, change ECU, fuel pump work good, all fuse are good, ground all check, when I turn key on II I hear the main relay click but no fuel pump and engine cranked but no spark. please tell me what going on with this problem, Please help.

Posted by on

  • 1 more comment 
  • Anonymous Mar 16, 2014

    90 camaro rs 5.0 engine new fuel pump new relay turn key on no pump noise or will not ru

  • Anonymous Mar 20, 2014

    check engine light doesnt even light at begining cycle of key

  • Anonymous Mar 24, 2014

    I have a bmw 318is 1,9l 1998 model no spark have aligned the ews key and dmsand the car just swing does not pump fuel and fuel pump is new but there is no fuel coming checked voltage on the connectors its there but still nothing is happening engine was recently done what could be the problem pliz help



2 Answers

You mean the main relay cornect get burned up? my main relay not click when I turn the key on II then I change main relay but still the same, I check all wire in main relay cornect they all have power, I think I don't have enough ground in it, then I try to cornect derect outside ground to it then I see the check engine light on then it stay on but not off after 2 second and i hear the relay click only one but the fuel pump still not pump then I try to start but it still won't, still have no spark, then i try to read code from the ECU, but don't see any light on from the ECU. or ECM even i try change the ECU but still don't see anything change.

Posted on Oct 11, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 360 Answers

Main relay contacts get burned up...... common on the hondas its under the drivers side dash

Posted on Oct 10, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

91 acura integra start problem

Did you check the timing belt timing? Engines need 3 things to start. Spark, fuel, compression.

Jul 05, 2014 | 1991 Acura Integra Hatchback

3 Answers

94 Acura Integra wont Start

jump timing loosen distributor and plus or minus turn and retighten

Mar 09, 2013 | 1994 Acura Integra

1 Answer

1994 integra rs won't start

check your computer or the ignator or coil in the dizzy

Nov 12, 2011 | 1994 Acura Integra

1 Answer

1991 Integra Hatchback: I have a 91 Acura Integra. I am having a problem t...

Take out the main relay and check the solder joints.
Reheat the solder joints if you see any tiny cracks.
You can also buy rebuilt main relay from eBay.

If the main relay does not solve the problem, you will need to check the distributor. Open the distributor cap and the rotor and see inside and make sure there are no oils leaked from the bottom side of the distributor through oil seal. Replace the distributor with a rebuilt or new one. There are many distributors listed at eBay.

May 18, 2010 | 1991 Acura Integra Hatchback

1 Answer

1992 acura integra no spark no fuel

crazy,but I will ask,is the rotor button turning?Is the timing belt broken?Have you replaced the components in the distributor with all new parts?The pick up coils are bad to go out,and the modules,and the coils.

Nov 02, 2009 | 1993 Acura Integra Hatchback

4 Answers

Doesn't start

To put it simply it's either spark, fuel or compression. If the timing belt is okay (not broken or timing marks don't line up) and you have spark, you need to make sure you have clean gas and not water (from condensation) or air being sprayed out the injector nozzles. Try using quick start spray or even pouring some gas down the trottle body and see if it starts. If it does then check the relays, pump and lines. I've seen pin hole leaks in lines that caused symptoms similar to vapour lock. Check the
Main EFI relay (it's under the dash near the brake pedal) they usually stop working when the car is parked in the hot sun. Sometimes leaving the doors open, or pushing the car into the shade so it can cool down, will get the car to start again. I would get a distributor and a Main EFI relay from a junkyard. Because it's too expensive just swapping in new parts, and it's always a good idea to keep a spare distributor around as they are known to go bad on old Integra's.

Aug 18, 2009 | 1993 Acura Integra Hatchback

1 Answer

No spark, no start

There are typical problems on the Tegs, you should check your main relay, it is underneath the steering column area, look for 1x2 box, might be drown or black. Pop it open and see if there are cracks on the solder, you'll have to look real close. If there are, find a buddy that knows how to solder and redo them. Remove old solder and replace. The next thing you should check is the distributor. This symptoms for the distributor is well no spark, usually after it's been driven, it dies then no spark. good luck

Apr 18, 2009 | 1993 Acura Integra Hatchback

3 Answers

Turns over but wont fire!

How do you know it's getting fuel and spark? do you know if the fuel is good? and not watery?
are you getting any check engine light?

Nov 17, 2008 | 1990 Acura Integra Hatchback

3 Answers

Car will just turn over no spark, i replaced the distributor, ecm, battery, but can't find the main relay would that cause the problem

Hi. You may wanna try to change the ignition transformer. A good way to troubleshoot is to unplug the cable from the distributor cap end and hold the cable a half inch away from the chassis or the engine head cover and try to strart the engine. If you see a sparl coming from it from the cable, the ignition works. if not, change it. Hope this works for you.

Aug 21, 2008 | 1992 Acura Vigor

Not finding what you are looking for?
1990 Acura Integra Hatchback Logo

579 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides