I have a 1993 dynasty and it wants to chug when i come to a stop and almost stall. It chugs when i go to accelerate also if i put the car in neutral it wont do it though. any ideas?

code p 0720 refers to output shaft speed sensor (OSS)---circuit malfunction===causes ---wiring --- OSS sensor--- ECM---TCM
as the OSS reports shaft speeds to the TCM so that he correct ratio can be selected, I would be having it tested / replaced

There are numerous things that will cause this problem. If the check engine light is on, have the codes checked to see if there is a problem the computer has found to cause this issue. Even without the check engine light on, there may be a code stored. You can also do a visual inspection under the hood for any disconnected hoses causing vacuum leaks. These are the best places to begin with diagnostics

I doubt it. You should have the computer checked for trouble codes.
It could be a long list of things including low fuel pressure.

the fuel pump is going bad

Is the check engine light on ?
It sounds like the engine temp sensor is not right, but if that were true you should have a check engine light and a code for the sensor.
Have you checked fuel pressure ?

try blowing out all the fule lines and changing the fule filters the lines may be blocked up also check the fule tank vent if this is blocked the pump cant **** fule from it

Clean, inspect and, or, Replace your crank sensor or, crank sensor wiring A loose crank sensor bracket or, a start relay has caused this before

check all your air lines

mcdevito75 here, Sounds like the idle speed motor, Ford is known for these idle speed motors going bad, in the later stages the car races like crazy. have your repair shop check this idle speed motor and change it.

Check engine light?