Question about 2008 Saturn Outlook
How do you get to the light
Turn your wheels all the way to the right ot left depending which side you are changing out. take a phillips head screwdriver and take off plastic wheel well cover then you will be able to reach up inside and change out bulb.
Posted on Nov 29, 2009
To my knowledge a 2003 Toyota Camry uses a dual filament halogen bulb, either by Osram, Philips or Sylavania. If on the dashboard, the blue indicator lits when the switch is moved to bright or the passlight is engaged but no headlight, then it could jut be busted bulb (or part of it since you still have driving/low beam). In some cases, it could be the relay that supplies power direct to the bulb. At other times, it could be fuse(s) assigned to high beam. At certain instances, it could be also a loose, corroded or burned connector.
Corrective measure for your concern would be to check the 2 bulbs. This is performed by removing the rear covering (rubber or plastic cap) of the headlight assembly from the rear. The bulbs are held in place by a spring clip that needs to be unlatched from the base/holder. Carefully remove the bulb taking care not to touch the glass envelope. The filaments would be readily visible and cut/breaks would be apparent. If determined that one of the filaments (high beam) is open, replace the bulb(s).
If the bulbs prove to be OK, you need to work yourself backwards tracing the wiring harness. After the bulb, check the 3 prong connector for any corrosion or scorching/burnt marks; clean as maybe required. Next to check would be the relay that provides the +12VDC and then the fuse.
I doubt if the dashboard or steering wheel components involve with headlights may be at fault.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
Posted on Jun 02, 2008
My niece has a jimmy, they should be the same. The inside should be the high beam, the outside the low, DO NOT TOUCH THE GLASS ON NEW BULBS! Oil will cook on them and pop them! Both come off the same way. Take off the big rubber thing. They are soft but over hard plastic. Just pull them off. If you have trouble, you can flip the little wire clips that hold the headlight housing in place, this will give you room to see the rubber caps enough to figure them out better. The bulb assembly rotates CCW counter clockwise, and should slip out easily. Take the wires and plug off. it should be obvious how it pulls off. Snap the new bulb into the wires without touching the glass part. Gently replace in backwards order as you removed it. Put the rubber caps on, they keep water off the bulbs. It will break them!
The passenger side was harder for me. I had to take the air cleaner off, the whole cover and filter.You should be able to see or feel the same type caps, The low beam outside, High beam inside. The same 2 wire clips are there to release the housing. Everything pretty much goes the same, other than the air cleaner has to be removed and replaced. And make sure the rubber cap is replaced! Good Luck and good motoring!
Posted on Dec 19, 2008
SOURCE: Low beam headlights don't work
I have e-mailed you 2 .pdf files, one is the complete headlamp diagram, and the other is the relay locations. Please advise if you need further assistance.
Posted on Jan 02, 2009
it more then likey a lose wire or bear one. run the line down. i think that the high beams run on diff. fuses. you can try that!
Posted on Jul 13, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
May 19, 2016 | 2001 Volkswagen Beetle
Dec 20, 2015 | 2004 Nissan Sentra
Oct 04, 2013 | 2005 Jeep Grand Cherokee
HEADLIGHTS NOT WORKING
can be faulty headlight switch or issue with its wiring. Or its faulty head
troubleshoot the issue i suggest you few help links with appropriate solution.
So you can follow the test and confirm what exact problem is there in your case
of headlights not working:-----
the link below: -----
• Car headlight bulbs don't last long?
How to Replace a Headlight
How to Replace a Headlight Bulb
How to Replace a Headlight Switch
How to Replace a Headlight Assembly
How to Replace a Park Light Assembly
Nov 28, 2012 | 1986 GMC K1500
Nov 22, 2012 | Cars & Trucks
Oct 11, 2012 | 1997 Jeep Wrangler
Aug 02, 2011 | Nissan Pathfinder Cars & Trucks
Feb 07, 2010 | 1993 Honda Accord
Aug 13, 2008 | 2001 Toyota Tacoma
886 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: