Question about 2000 Mitsubishi Galant

1 Answer

Wont start Just bought this car, it has a viper security system,supposably disabled, but the car will not start. the motor turns but wont start,

Posted by on

  • dmvdjw Oct 09, 2008

    Also, the engine light are not on, so i do not think it is a sensor.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Ok you need to completely remove the alarm system, I just had the same exact problem and just paid a guy 35 to pull it out and now it is fine on that issue

Posted on Jan 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 pontiac wont start replaced battery starter ignition coils spark plugs wires still wont start


Is the security light lit on the instrument cluster . Anti- theft system disables the fuel injectors

Jul 06, 2016 | Pontiac Cars & Trucks

1 Answer

The security light comes on but it wont even turn over


When the light is on, the security feature of immobilizing car-wont allow starting-is active. Pretty difficult and time-consuming to permanently disable the security system, but some have figured it out and published their research over the internet. If yours gets worse, if the light stays on more frequently, you may want it permanently removed. I think it was a ruse by GM and car makers to add cost, and cause more frequent repair visits, but that just me.
Google "disable vehicle security system" or some such, to see results.

Dec 29, 2012 | 1999 Oldsmobile Intrigue

1 Answer

99 mercury cougar wont crank no spark anti theft light flashing


a bad security system would restrict the ignition system from activating so the engine may be perfectly fine but until the security system give it the ok, its gonna sit. have someone take a look at the security system and see if they cant fix the system or deactivate it (what use is a security system if your car wont start right?)

Oct 20, 2012 | Cars & Trucks

1 Answer

Security system


Lock all your doors manualy use the key and unlock drivers door then put key in ignition and start it.

Aug 22, 2012 | 2000 Cadillac DeVille

1 Answer

I have a 1991 cadillac eldorado when i try to start it it says starting disabled due to security system failure remove key and wait three min but still wont start


This is a very common GM problem. The anti theft system that is supposed prevent the theft of your vehicle fails and is now locking you out. Go to this site for info and answers that you can do yourself. http://vatspasslockpasskeysecurityhelp.yolasite.com/

Jul 09, 2011 | 1991 Cadillac Eldorado

1 Answer

I have a viper alarm on my car that wont shut off nor i cant start the car..and i have tried the button under my dash, how Can i shut it off??


was it a professional or shade tree install? the following is off vipers website:
disarming without a remote control
This feature allows you to disarm the security system without the
Remote Control should it be lost, damaged, or disabled. In order to
disarm the system without a remote remote control, you must have
the vehicle’s ignition key and know where the Valet button is
located. Be sure to check with the installer for the location and the
number of presses of the Valet button required to disarm the system.
To disarm the security system,
turn the ignition to the ON position.
Press the Valet button the
preset number of times (one to
five times) within 15 seconds. After five seconds the system will
disarm. If the system does not disarm, you may have waited too long;
turn the ignition off and on and try again.
if that doesn't work try this other

valet mode
You can prevent your security system from automatically arming
and triggering by using Valet Mode. This is very useful when
washing the vehicle or having it serviced. In Valet Mode, the
security system will not arm, even with the Remote Control, but
all convenience functions (door locks, trunk release, etc.) will
continue to work normally.
To enter or exit Valet Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
button within 10 seconds.
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.

May 08, 2010 | 1994 Honda Civic

4 Answers

Security light is flashing on 03 grand am


Everything you need to know is on this link

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Mar 26, 2009 | 2003 Pontiac Grand Am

1 Answer

Car wont start


as long as security theft system is on, car wont start.

don't you have the remote key to disable the theft system?

you can bypass security but you have to have wiring experience and splicing before you can proceed.

tnx 4 using fixya,

drcool

Oct 14, 2008 | 2000 Cadillac DeVille

Not finding what you are looking for?
2000 Mitsubishi Galant Logo

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...