Question about 1998 Lexus Sc 300

1 Answer

Fog light bulbs

How do i change the bulb in a 97 sc300 foglight

Posted by on

  • jovianmata May 13, 2009

    I have a problem with my 95 SC300 there is to much play in the steering wheel. How can I fix this myself?



1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

You need to remove the plastic under the car, it should either be bolted or screwed in. Pull this down and you should have access to the bulb, a rubber cover and a clip holds the bulb in. No need to remove the entire housing.

Posted on Jun 29, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My foglights won't light up except for the side

You are aware the headlights must be on low beam before the fog lights will come on?

Nov 09, 2017 | Cars & Trucks

1 Answer

2010 Dodge Avenger R/T fog lights not working

Check the light bulbs themselves. If those are still good, (don't touch the glass on the bulb), then check all your fuses. Chances are, the foglight fuse is linked in with something else.

Jan 15, 2014 | Dodge Avenger Cars & Trucks

1 Answer

Renault scenic front foglight bulb

I found the easiest way to change the fog light bulb is to take bumper off, takes 5 mins, 5/6 screws/clips across the top were the bonnet meets the bumper and a few clips on wheel arches then pull off and 2 spot lights very easy to Accra.

Mar 31, 2012 | 2003 Renault Renault Scenic 1.6

1 Answer

Foglight does not go on how do I replace bulb

u must get under the front bumper, the fog light bulbs are replaced from the back, do not touch these bulbs when installing ot they will crack the 1st time u trurn the fogs on for more than a few minutes

Apr 22, 2010 | 2005 Dodge Neon

1 Answer

Fog Lights won't come on?

Check fuses,
Note you probably must have parklights 'on' before foglights will operate (Check user manual for fog lamp operation (interlock) requirements),
Check operation of fog light relay (if fitted),
Check fog lamps and bulbs are ok.

Jan 22, 2010 | 2001 Volkswagen Beetle

1 Answer

Verona 2005 fog lights won't work. Fuses are ok, lightbulbs are ok. Fog light switch lites.

Remove the entire foglight assembly check for a loose wire inside the assembly. I had the same problem on mine but it only affected one of the foglights. Also check with a test light at the connector where it connects into the foglight assembly. Also make sure foglight bulbs are properlly tighted.

Dec 08, 2009 | 2005 Suzuki Verona EX

1 Answer

Changing factory installed foglight bulbs on 2008 elntra

Your 2008 Elantra fog lamps are probably still under warranty. Take the vehicle into a Hyundai Service Center (dealership) or call the nearest one. Give them your vehicle VIN and ask them if the fog lamps are still under warranty. If they are, they will replace them for FREE!

Jun 20, 2009 | 2008 Hyundai Elantra

1 Answer

99 A4 tali light assmbly missing top bulb passenger side

That's the rear foglight socket. The rear foglight idea is European, and they ship the Audi over with a rear foglight as well, but it's only on the driver's side (that's the way rear fogs are done in Europe). That socket is fully powered though, and wired to the same dash switch as the driver's side rear fog. What you can do (what I did on my 99 A4) was to use a drill and **** out the rectangular opening in the rear taillight panel, and then put a bulb in that socket. Voila, instant dual rear fogs.

This is a good idea because in Europe, the police understand that a rear fog is only on one side. In the US, our police don't always know that, and you may get pulled over if you have that on - they may think you have a blown taillight bulb. Do the dual fog mod as described above - it'll save you the hassle and it looks better too.

Feb 08, 2009 | 2006 Audi A4

1 Answer

I have a UK registed, Feb 2000 AUDI A6 2.7T QUATTRO AUTO ESTATE, Is it right that these are fitted with just one rear fog light that operates and the other is just for show.

Yes it's true. What I did on my US-spec A4 is to pull back the trunk lining on the passenger (right) side, where there is no functional foglight (my rear fog from the factory is on the left side). What I found was that the "bulb tree" has a fully powered socket for a bulb that would fit into a rear foglight on that side, but no bulb was installed. The part of the taillamp that would have a hole for such a fog bulb had a **** instead. I used a drill to widen the **** into a hole large enough for a bulb, and installed a bulb in the bulb tree, and voila - dual rear fogs:)

Jul 21, 2008 | Audi A6 Cars & Trucks

Not finding what you are looking for?

Open Questions:

See all 1998 Lexus Sc 300 Questions

Cars & Trucks Logo

311 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts


Level 3 Expert

77947 Answers


Level 3 Expert

917 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides