How to get pully off power steering pump
You will need a power steering pump pulley puller. Check with your local parts store to see if they rent or sell one.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
SOURCE: removing water pump on 97 grand prix gt. Power
no you have to go thru the holes in the front of the power steering pulley. Usually a ratchet with a deep 13mm socket will do to remove the 2 bolts located at 12 and 6 o'clock then you will be able to move it out of the way
SOURCE: power steering pump
The pump has to be removed from under the vehicle by removing the exhaust system from the flex bracket and moving it to as far left of the vehicle as possible..remember you have to remove the splash shield that protects the engine components first...then remove all associated bolts,hoses (plug them so they won't drip) and remove the pump from the vehicle..that it.
SOURCE: Camaro Water Pump!!!!
usually, the socket wrench would fit in the holes of the steering pulley. that is what they are for.
the steering pulley has three holes and you can adjust it so that the sockets could go through it and loosen one of the bolt that is holding the power steering pulley.
tnx 4 using fixya,
drcool
SOURCE: power steering pump leaking
Dear bigwood_84, Sat 02-21-2009 12:46pm EST (USA)
Try a can of "Bars' Leak" for power steering leaks 1st available at your local auto parts store. It's cheap and can't hurt but may fix your problem!
Advanced Auto Parts has a tool lending policy and a lot of good advice!
jack
Please Rate This!
SOURCE: removing power steering pump
To replace the power steering pump, proceed as follows:
678 views
Usually answered in minutes!
×