Question about 1993 Dodge Dynasty

Open Question

FUSE DIAGRAM DOES ANYONE HAV A FUSE DIAGRAM FOR A 1990 DODGE DYNASTY?

Posted by on

  • KEVIN DEROSIER Oct 09, 2008

    emissionwiz-thank you

  • yadayada
    yadayada May 11, 2010

    The fuse diagram should be on the back of the cover that you pulled of the fuse box. If the diagram is not there than you can go to any general automotive store and buy the Dynasty book for about $35.00

×

5 Suggested Answers

SOURCE: 1997 Dodge Caravan Fuse Box Diagram

runs hot

Posted on Jun 13, 2008


  • 3 Answers

SOURCE: 1990 dodge dynasty

Same thing happened to my '89 Dynasty. Turns out the security system was engaged and this stops the motor from running; therefore. a thief cannot drive away with the car! The system is set by using the power locks or an autolock fob, but not by locking manually. Disconnecting the battery will also engage the security system. To disengage, close the driver or passenger (front) door and turn the key in the lock.

Posted on Oct 07, 2008

  • 1 Answer

SOURCE: I HAVE A 1990 DODGE DYNASTY.HOW DO I FIX THE HEATER BLOWER THAT STOPPED WORKING?

it could be a 7 dollar resistor thats bad. Thats located behind the fluid washer resovoir.

Posted on Dec 15, 2008

royhyreno9
  • 50 Answers

SOURCE: SERPENTINE BELT DIAGRAM FOR 91 DODGE DYNASTY

go to your local auto parts store they will print one out for you advance auto or auto zone is your sure bet

Posted on Jan 06, 2009

emissionwiz
  • 60691 Answers

SOURCE: 1990 Dodge Dynasty LE 3.3L replaced Trans Speed

the next step is to have a scanner hooked up with live data capabilities and see if the speedo is getting a signal from the VSS, if it is then the speedo stepper motor that moves the needle is defective and the unit must be sent out for repair..

Posted on Mar 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The wipers on the car stay on if the fuse is in but will not work with the switch. we have to take the fuse off for the wipers to stop. 1990 Dodge Dynasty


There is a parking circuit in the motor which allows the motor to shut itself off after it lowers the arms to the rest, parked, position even after you have shut off the wiper switch. Sounds like that circuit has gone bad so a new wiper motor is in order. Sometimes these are easy to get at and sometimes they are a real *itch, take a search on www.youtube.com for someone pulling the wiper motor on any late 80s or early 90s Chrysler product, they will all be about the same; or buy a repair manual on CD over on eBay.

Jul 13, 2011 | 1990 Dodge Dynasty

1 Answer

I have a 1990 Dodge Dynasty 3.3L V6. My speedometer stop working so did my trip miles, can anyone please help. I'm mechanically incline I just dont have the time to figure it out can someone point me to...


if it has a 413 trans the speed sensor is right where the passenger axle goes in. If you do not see one there it has a 604 trans and the output sensor is on the front up towords the radiator you will see two round sensors the one you need to change is the one closer to the driver side.

Nov 18, 2010 | 1990 Dodge Dynasty

1 Answer

Heater hose diagram for 1990 dodge dynasty. The heater hoses where conected togather due to a bad heater coil that has now been replaced I need to know how to put heater hoses back where they go and I am...


remove the hoses at the temp conection inspect them to make sure they are good them follow the one that comes from the pump housing goes to the top of the heather core outlet and the return one to the bottom this may be a bit diferent if the engine is 6cyl or 4cyl.

Sep 08, 2009 | 1990 Dodge Dynasty

1 Answer

I have a 1990 dodge dynasty with an a/c drain line blockage.


Should be on the right lower side of the firewall. Most cars have a black ribber elbow on them. Take a wire coat hanger and just insert a couple of inches in the tube, not to far to wher you poke the evap.

Jul 31, 2009 | 1990 Dodge Dynasty

2 Answers

Need drive belt diagram for 1990 dodge dynasy


CLICK HERE

depending on your installed accessories - it can be different.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Apr 15, 2009 | 1992 Dodge Dynasty

1 Answer

Anti theft alarm won't shut off


Lock all doors..Then with the key unlock passengers side door then it should stop..

Apr 04, 2009 | 1990 Dodge Dynasty

1 Answer

Where is the ignition module located on 1990 Dodge Dynasty?


This car does not have one but it does have a crank sensor!located on the top of the trans bell housing

Apr 03, 2009 | 1990 Dodge Dynasty

1 Answer

I need a blueprint of my 1990 dodge dynasty


autozone.com will have all the diagrams for this car , but not actual blueprints . hope it helps .

Nov 26, 2008 | 1990 Dodge Dynasty

2 Answers

I HAVE A 1990 DODGE DYNASTY.HOW DO I FIX THE HEATER BLOWER THAT STOPPED WORKING?


it could be a 7 dollar resistor thats bad. Thats located behind the fluid washer resovoir.

Oct 08, 2008 | 1993 Dodge Dynasty

Not finding what you are looking for?
1993 Dodge Dynasty Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...