Question about 1997 Hyundai Accent

2 Answers

Hyundai knocking its more of a juddering sensation with a banging noise when accelerating or turning corners slowly

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Sounds like mounts to me....

Posted on Oct 16, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 566 Answers

Hiya if you are sure that the n/s/f wheel bearing/cv joint/ and suspension joint/s are sound ? may i suggest that you check the engine mountingson the n/s front +rear ? from your symptoms it sounds very much like as you accelerate the engine is tilting due to the metallastic mounting has perished thus the juddering is engine moving along with driveshaft especially cornering ? you will have to check physically and visually the mountings or pop into local quick fit and ask to check for normally no charge? for inspecting this is common fault easilly missed on a lot of cars with f/w/drive hope this helps ?

Posted on Oct 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Banging noise when you drive


This is a hard problem to describe, I know, and I will toss out a few possibilities. If the noise occurs when the car is accelerating, it can be motor mounts, or carriage mounts on front-wheel drive vehicles. Transmissions can bang into gear. Drive shaft u-joints can bang before they fail. C-V joints in front wheel or 4 wheel drive units can bang when worn out.

The exhaust system can break loose and bang on the frame. Brake calipers can rock in their mounts and transmit sound. Tie-rod ends can make a knocking noise on every bump you hit. There were recalls on gas tank straps for some Ford made units, so a loose gas tank can bang.

Dec 30, 2013 | Mercury Cars & Trucks

1 Answer

Knocking engine 2004 hyunda elantra


tick or knock ???

tick could just be valve train noise that either could be adjusted out or live with it

engine knock, well hopefully you dont have payments

Dec 29, 2013 | Hyundai Cars & Trucks

1 Answer

Car juddering when foot off the accelerator Hyundai Amica


is it auto matic or shift . if shift its clutch judder oil on clutch plate

Nov 05, 2013 | Hyundai Cars & Trucks

1 Answer

Loud knocking noise engine


Have a oil pressure test done on the engine to determine bearing failure. Have a compression test done to check for internal damage such as broken rings/pistons or overheated motor.. If the noise appears during acceleration then run the fault codes and look for a tuning problem or failed knock sensors

Sep 20, 2013 | Hyundai Elantra Cars & Trucks

1 Answer

Very occasionaly ( 3 times in the last 4 months ) when i decelerate at a corner and then accelerate I have a loud bang. It apears to be the gearbox. Other than that I have no problems with gear changes...


If this happens when you turn both ways, I would suspect an engine or transmission mount. When you accelerate the engine is being lifted somewhat off the frame and the bang would be when it comes back down. If you only hear it on say a right turn, then I would suspect a CV axle or possibly a ball joint on the right side. Hope this helps.

Aug 30, 2011 | 2003 Porsche Cayenne

1 Answer

Juddering and noise on front wheels when braking


The disks may be warped, which will cause a vibration under braking.
Also if it's an ABS system, the vibration is normal but only under heavy braking, and should not continue to vibrate when working properly.

Jul 24, 2009 | 2002 Hyundai Santa Fe

1 Answer

Accelerated clicking/knocking noise when i start driving


sounds like your CV joints are worn out. If the clicking noise gets worse when turning then its a definite possibility. Also check the CV joint boots for splits as this can quickly wear them out. The dust mixes with the grease to form a grinding paste.

Apr 07, 2009 | 2000 Hyundai Elantra

2 Answers

Knocking sound


maybe cv joints. check cv boots to see if torn or look out for grease marks in the area behind front wheel. This would be more clicking noise though and not banging.

Oct 08, 2008 | 1997 Hyundai Accent

1 Answer

Audi A6 Avant 1.9tdi 2004. Knocking/clicking noise when turning from front wheels


Lou,I belive your right.When an axle goes this is the sound they make.

Sep 05, 2008 | 2004 Audi A6

1 Answer

SHAKING AND KNOCKING NOISE


it could be tht the exhaust pipe is loose and therefor makes shaking and kinda banging noise. hope i helped! ;-)

Jul 26, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1997 Hyundai Accent Logo

358 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...