Question about 2000 Chrysler Concorde

1 Answer

BRAKE LIGHT REMAIN ON

HAD A FAULTY AFTERMARKET ALARM REPLACED. NEW ALARM WAS ACTING QUIRKY AND THE GAUGES STOPPED WORKING ON CAR, PERSON REPLACED WITH A NEW ALARM, SAID FUSE WAS BLOWN AND REPLACED. GAUGES WORK NOW BUT THE BRAKE LIGHTS REMAIN ON UNLESS YOU PULL FUSE. THE ALARM PERSON SAID THAT HE ONLY DEALT WITH WIRES FOR ALARM. THE CAR HAS HAD QUIRKY ELECTRICAL PROBLEMS BEFORE. ANY SUGGESTIONS WHAT TO CHECK OUT?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 70,387 Answers

The installations of alarms I have seen over the years were with few exception very very poorly done, and always the cause of the electrical issues like yours and 100's of other problems, the alarm installer always denied there alarm was at fault, but when I restored the factory wiring the problems went away, HUM!, I will bet if you restore the wiring that everything will work again as designed.

Posted on Oct 08, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a brake failure (intermittent) on an '03 Statesman. Pedal goes almost to the floor (but still works somewhat) brake failure light and alarm comes on. If you stop a while, shut down and restart all...


I take it that the brakes worked properly after it was fixed. If this is the case, I would suspect a faulty master cylinder again. This is typical with cheap aftermarket, or rebuilt parts. But to be sure, have the shop run new brake fluid through, opening every bleed screw, make sure the brakes are bled properly.

Dec 10, 2014 | Cars & Trucks

1 Answer

Gauges move when stopped


Sounds like it could have a weak alternator. In gear the idle is always lower than in park. A low voltage situation could cause the gagues to act up

Nov 26, 2013 | 2006 Kia Rio

1 Answer

Temp gauge pegging out, but engine isn't hot to the touch.


You could replace the sending unit to cross it off the list of possible problems.
You could check resistance cold and then with the engine at normal temp too. The gauge on the dash could be faulty too.

Jan 15, 2013 | 1998 Dodge Neon

1 Answer

New battery drain over night


Possible diode pack in Alternator bad, dome light left on, aftermarket stereo equipment left on or installed incorrectly, aftermarket alarm system faulty, ignition switch faulty lastly an internal short in some other sysytem. Must pull fuses one at a time while using a volt meter or test light to islolate the problem.

Apr 10, 2011 | 1998 Jeep Cherokee

2 Answers

Gas gauge does not work on my 2005 Chevrolet Trailblazer.


If it's not acting quirky, replace the stepper motor on the back of the guage. Easy and cheap. If it's intermitent, replace your ignition switch. Both are common problems with TB's.

Feb 23, 2011 | 2005 Chevrolet TrailBlazer

3 Answers

Gas gauge is not registering level consistently . level changes up and down. i fill gas tank up and it will go down to a3/4 of a tank fairly accuratly then gets erraic, going to full and back 3/4 very...


sounds like its time for a new sendinding unit, this is the part that hold the fuelpump inside the tank, and has a float arm, this is what tell you how much gas is in the tank, heres a picture of it,this comes with everything even the pump,also make sure to wire in the new connector,these trucks have connector problem,good luck.also check the ground that go to that connector, follow them,may go to rear frame on the leftside, remove and clean them.d2f4ba0.jpg

Apr 07, 2010 | 1999 Chevrolet Blazer

1 Answer

When I turn on my headlights my speakers stop working, the stereo still works but no sound comes from speakers, also when I press on brake the interior ''lights'' light comes on and goes off when I take...


check to see if someone may have put in a aftermarket alarm..someone must of really screwed that up. Take off the panel under the steering column and also check the kickpanel for any wires that may indicate someone tried installing something aftermarket. Not necessarily alarm. Could of been extra lighting or any arrangement of electronics.

Aug 10, 2009 | 1991 Toyota Camry

1 Answer

Car alarm stopped working.. Car wont start


the jetta has a faulty alarm system from the factory i have been working on one in my shop. the alarm moddule is inside the dash behind the light switch and has a 10 pin connector and a 6 pin connector. this can be bypassed if you disconnect both connectors and jump the two large wire on the 6 pin connectors, these wires operate your starter. the car will start and run but your alarm will no longer be active. the door locks and everthing else will still work. the only issue i am having is the factory radio isn't working because it is controlled by the alarm. but worse case scenario i can use an aftermarket radio if need be.

Feb 20, 2009 | 1994 Volkswagen Jetta

1 Answer

89 Crown Vic brake lights work when park, not when moving.


Replace, or adjust your brakelight switch located on the brake pedal arm.

Sep 16, 2008 | 1989 Ford Crown Victoria

Not finding what you are looking for?
2000 Chrysler Concorde Logo

Related Topics:

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6879 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...