Question about 1997 Honda Civic del Sol

1 Answer

Speedomator My speedomator gage goes up and down like is has a lose connection.

Posted by on

  • dickphillips Apr 08, 2009

    speedomater bounces has new cable

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 92 Answers

SPEED CALBE NEED TO BE REPLACED

Posted on Oct 08, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 GMC Sierra Duramax Diesel 2500HD Allison Transmission temperature gage rises and overheats when going up small and large hills immediately goes back down at top of hill or when we turn air off. Also...


you have to find out why it's overheat ,trans.pipe bent,cooler restrictions,
the pcm know trans.overheat and goes to default mode
have code retrieve

Aug 23, 2013 | 2007 GMC Sierra 2500HD

1 Answer

Grinding noise over 30 mph


you would have to find out where the speedomator wire/cable
connects
heres some idea

there is a gear at the end of a speedomator cable

try this 1st hit me back if this dosent work

Nov 01, 2012 | Mazda MX-5 Miata Cars & Trucks

1 Answer

Cam senor


this is possibly a loose eleectrical connection at starter battery or alternator check tightness clean connections

Nov 10, 2011 | 1997 Mercury Sable

1 Answer

Gas gage and speedomator dnt work


may have IPC problem?? but FIRST disconnect 1 battery cable (either cable can be disconnected for this) and touch cables together for 10 seconds. reconnect cable and see if they operate. this is a proceedure for doing a master module reset. this will clear all modules and codes. good luck.

Oct 29, 2011 | 1996 Pontiac Grand Am

2 Answers

93 jeep cherokee-while cruising down interstate jeep sudenly started jerking, stalling, and lose of power. I pulled over to station. checked oil level, pressure, temp, alt output--all ok. jeep will start...


I don't know engine size? The fuel pressures I found was 31--39 psi, 92--95. I would use a gage and check proper fuel pressure.
How long since over-all tune-up? Any applicable trouble codes?

Apr 28, 2017 | 1993 Jeep Grand Cherokee

2 Answers

Truck runs great but the oil pressure gage goes zeros out


Did you find the sending unit and was that the problem?

Oct 05, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

My speedo has not been working today all the other gages went out and after about 4 hours started working again


It sounds like the connection to your dash gage may have gone lose do to everyday vibration. If everything was running fine without any check engine or service engine soon, then it's your dash gage. Before your start your truck and the key'sare in the run possition, your gages should move up then down checking it's self. Keep a eye on that. Good luck. easy fix dubble check connection. 

Apr 06, 2009 | 2003 Chevrolet Suburban 1500

1 Answer

Speedomer not working


vehicle speed sensor located on the top of the rear axle.

Mar 23, 2009 | 1999 Dodge Dakota

1 Answer

Speed


The speedometer is driven by a signal from the Vehicle Speed Sensor (VSS). The VSS is mounted on the Power Steering Speed Sensoron the top of the back of the transmission (differential housing). There is an electrical connector and two small screws that hold the VSS to the PSSS. Be careful, there is a small link (key) that is between the VSS and PSSS which mechanically drives the VSS.

Feb 07, 2009 | 1992 Honda Accord

Not finding what you are looking for?
1997 Honda Civic del Sol Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

78238 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...