Question about Mazda MPV

1 Answer

I have a 1996 MPV that all of a sudden it started to rev high and low, meaning I didn't need to step on the accelerator, it would accerate all on its own and when stopped I revved it up and it started to go high/low. Have been looking for a vaccum leak but no problem solution yet. It's like it's hunting for where it needs to be.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 231 Answers

Use a can of WD-40 and spray it on the vacum lines and around the intakemanifold when the engine is hot and running. This will cause the engine to rev up when it is sprayed on the vacuum leak. be sure that the engine is at operating temperature as this is when the vacuum lines and gaskets tend to fail.

Posted on Oct 07, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

F22a engine produces strange noise most obvious at 2000 rpm, what could the problem be?


Without a general description of what the noice sounds like, squeal as compared to knocking, it is impossible to help you. Engines make a lot of different noises, so try and help by describing noise. I would suspect it is belt related, or tension pulley related as these are RPM variable noises, belts tend to slip when you accelerate and can be quite loud with a serpentine belt as example.
CERACOAT-NANOTECH.com

May 14, 2015 | 1996 Honda Accord

1 Answer

Car accelerates itself


If it is an auto then it is possible it is idling to high and the trans is still engaged despite you foot being off the peddle. Try lowering the idol speed as a first resort.

Oct 25, 2013 | Mazda MPV Cars & Trucks

1 Answer

I have a 2002 Mazda MPV. When I start it and drive it revs really high. Sometimes i can take my foot off the gas and it will still accelerate, A LOT! Also when it does this it shifts really hard and there...


The transmission is slipping, have it checked for low fluid level, if that is ok then you need the transmission rebuilt or replaced with a factory rebuilt exchange unit.

Sep 06, 2012 | 2002 Mazda MPV

1 Answer

Will not start when cold have to hit the acelarator


Hi! Since stepping on the accelerator works, then I assume that your engine is carbureted and the carburetor is the problem. I had the same issue before when I had to step on the accelerator every time I start. Have your carburetor checked, the fact that you need to step on the accelerator means that the engine is lacking air for the amount of fuel in it. You might end up having to do a carburetor overhaul.

Dec 23, 2010 | 1996 Nissan Sentra

1 Answer

Check engine light on auto zone read codeP0404 replaced egr valve,air filter, added sea foam, and high octane booster. car still has check engine light on reading same code will not accelerate hesitates if...


When it revs high, is it down shifting? if so you may be running out of gas. low fuel pressure or lack of fuel getting to the injectors. (fuel filter)

May 02, 2010 | 2002 Chevrolet Impala

1 Answer

Gears slip


the transmission is fine its the springs in the preasure plate that have shrunk and the clutch needs to be replaced.
I hope this advice helps.
can u rate the advice please

Feb 26, 2009 | 1996 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...