An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert who has answered 1,000 questions.
Re: no alarm for lights on
I suppose you mean beeper does not go "on" when head lights are "on" and you open drivers door.In this case beeper's door switch may be dirty. Check also for any loose wire connection or faulty beeper relay.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
have a qualified auto electrician move the power for the lights to the ignition switch so that when you turn off the ignition the lights go off. or have a qualified put an extremely loud beeper in the light circuit so that it sounds when you turn off the ignition. Actually there is a beeper that sounds when you leave the lights on after you turn off the ignition.
does the key reminder work?? if so then there could be a problem with the tail light relay which feeds the body control module, that feeds the gauge module which feeds the beeper. I would advise taking it to the dealer, or a shop that does a lot of HONDA work. ,
possible ecm reset needed (electronic control module) This is easy to do at home with a pair of visegrips or a wrench set. anyway the idea is to disconnect the car batt for atleast 2-3 minutes and with the key out of the ignition replace the batt terminals and tighten them wait 2-3 minutes and then get in car turn key only to light the dash this is called the post, once the dash has sat in the active position for the time said 2-3 minutes, turn car off remove key replace key and start the car let it run for a min or so and then turn off and exit the car and proceed to activate the alarm if the prob still is there i then suggest an ecm test any mechanic or dealer will test it for a nominal fee, if there is any thing at all not right with the car this test will get to the root. and if the test is showing no problems with the car the issue is most likely in the electronic keychain alarm keylock box
REPLACED THE BLINKER/FLASHER/HIGH/LO/WHINDSHILD WHIPER UNIT $70 AT YOUR LOCAL AUTO ZOO EASY FIX THREE SCREWS FROM BOTTOM OF COLUM. REMOVE PLASTIC COVERS REMOVE 2 SCREWS FROM BLINKER UNIT REMOVE TWO CONECTORS AND INSTALL NEW