Question about 2002 Hyundai Santa Fe

1 Answer

Temperature readings I just changed my battery and now need to change my readings from centegrate to farenhight. Can you tell me how?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 74 Answers

Press and hold temp selection switches

Posted on Nov 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Change temperature reading in intellink from c to f


HIT THE MENU BUTTON ON UR TURN SIGNAL LEVER SCROLL TO "UNITS" THEN MOVE SCROLL UP OR DOWN TO CHANGE AND HIT SET --DONE

Nov 17, 2014 | 2013 Buick Encore

1 Answer

I change the temperature sensor but the needle does not move how can I change the needle? This is a 95 ford Econoline 350


you have probably been misinformed. The needle on the temperature gauge is controlled by the temperature SENDER unit ( not the temperature SENSOR unit) The sender unit is a single wire unit that is a resistance unit affected by heat of the coolant, The hotter the coolant the less resistance the higher the reading
The temperature sensor unit is a 2 wire unit that tells the ECM when to switch on the fan, when to go into limp mode if overheating and when to adjust the air/fuel mixture as the coolant warms up

Oct 20, 2014 | Ford Cars & Trucks

1 Answer

98jetta fault code p0117 replaced the battery and ect but volts at ect plugin still read just under 5 could someone also tell me what each wire goes to its a 4 prong


from what i have just read on other sites its the temp gauge thermostat for the fan as well.. so can only go on what they say. this is another site - The ECT (Engine coolant temperature) sensor is a thermistor located in the engine block or other coolant passage. It changes resistance with changes in temperature of the coolant that it's in contact with. It's usually a two wire sensor. One wire is a 5 volt reference from PCM (Powertrain Control Module) and the other is a ground supplied from PCM. As the temperature of the coolant changes, the resistance of the sensor changes. When the engine is cold, the resistance is high. When the engine is warm, the resistance is low. If the PCM detects a signal voltage lower than the normal operating range of the sensor then P0117 code will set.

Feb 21, 2014 | Cars & Trucks

1 Answer

97 ford explorer battery reading low change battery change alternator


Take it to Advance auto they do a system test for FREE that will tell you what needs to be changed. Or you can check it just start it up unplug battery if it stays running then the battery is bad. If it shuts off then its the alternator.

Feb 11, 2013 | 1997 Ford Explorer AWD

1 Answer

Changing the external temperature gauge from Fahrenheit to Celsius


If your temperature reads in climate control reads in degrees Celsius "C" instead of Fahrenheit "F", follow these steps to change to Fahrenheit.

  • Turn the ignition on.
  • With the climate control turned on, push and hold the recirculation button in. While holding the button in, push and hold the off button in for 3 seconds or until you hear a beep.

The display should then change to "F". Follow these same steps to change your read-out to Celsius , if preferred.

Sep 21, 2012 | 2005 Land Rover LR3

1 Answer

2001 land rover discovery change air conditioner temp readout from celsius to farenheit


To change the temperature reading from C to F (or vice versa), press and hold the recirculation button, then press the off button holding the switch down for 3 seconds or more until an audible beep is emitted. If the battery is disconnected and then reconnected, the temperature reading will revert to C. Turning the ignition on/off will not change the customer's set preference.
(See http://www.discotech.info/index.php?title=Climate_Control for more customer configuration options for the climate control)

Dec 28, 2009 | 2001 Land Rover Discovery Series II

1 Answer

Change mileage and temperature from english to metric


Look to see if you have an Info Centre on your dash. If you do push the Info button until mileage comes up and click Reset it should change from english to metric. Changing the temp is done the same way. If you have an owners manual it will tell you how to do it as well. Hope this helps

Jan 18, 2009 | 2005 Ford Expedition

1 Answer

99 honda odyssey coolant fans turn too late


You might need a new ECT - engine coolant temperature sensor. If it's not reading the correct coolant temperature it's not going to tell the fan to turn on when it should.

Is the check engine light illuminated? I'd bet the ECT needs replacement.

Dec 17, 2008 | 2002 Honda Odyssey

1 Answer

98 ford Exped. oil and engine light come on but go off on restart


did you check the transmission heat sensor or the intake air sensor these can be incorporated with temp guage on some vehicles

but theres also the problem of alternator is getting ready to give only
take an electro meter and hook up to cigarette lighter with a 2 post power maker and watch the voltage as your driving try to recreate the conditions that brought this about if the reading changes dramatically this will tell your alternator will need to be replaced at some point also dead cells in battery creates this little bump in electrical

Nov 20, 2008 | 1998 Ford Expedition

1 Answer

Temperature gauge


The best thing to do is read the ownersmanual and it should tell you how to do it in there

Aug 23, 2008 | 2007 Mercedes-Benz ML320 CDI

Not finding what you are looking for?
2002 Hyundai Santa Fe Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...