I have a 2004 chevrolet, Aveo. I have taken my car to the dealer twice for the air bag warning light coming on, and they cleaned the wire connection and fixed it. For the pass year the light has been on, also the clock works some times and then the light goes out and when it comes back on it reads 0100. Both these problems I lived with. Now I am having a problem with check engine light coming on and going back off. The two codes are U2105 and P0700. The car is running fine. I took it to the dealer and the light off but it's back. Can you help
-   I have both of those same codes, but I also have a 3rd code, U0101 - Lost comm. with TCM (Transmission Control Module).
I can feel the tranny slipping between gears sometimes, but usually only when the light is on. I spoke with a guy who thinks the connection is faulty and it could be as simple as opening the panel and making sure it's in there good. The tranny seems fine as long as the light is off, but when the light is on, it starts to slip. Any suggestions on fixing it w/o taking it to an expensive shop?
-   chrayres
Jan 04, 2009
-   the right airbag light is on,suddenly without warning and it remained
there.
-   Guest
Nov 09, 2008
-   air bag warning light keeps comming on. 6 times dealer repaired-   Guest
2. The 2 codes you have, lead me to the Transmission Control modual, Is there a 3rd code with those 2?? If so it would narro it down for me
3. From all my reserch for the air bag it leads to the Air Bag Diagnostic Unit, about $200.00, on line. Dealer cost is $240.00 plus labor. If under warrenty, they dont want to change...and eat the cost..
There is also a control modual under dash behind heater controls...which has something to do with the clock and a few other things???? Have not had the chance to get into it????
Im having a problem with the directional signals they work for about 2 seconds then stop any ideas?...
(More)
Im having a problem with the directional signals they work for about 2 seconds then stop any ideas? thank you
Im having a problem with the directional signals they work for about 2 seconds then stop any ideas?...
(More)
Im having a problem with the directional signals they work for about 2 seconds then stop any ideas? thank you
on a 1977 gmc pickup the fuel gauge does not work. I need to run a new wire from tank to gauge. old...
(More)
on a 1977 gmc pickup the fuel gauge does not work. I need to run a new wire from tank to gauge. old wire is nowhere to be found and there is no direct hookup to the gauge. it looks like it comes off of the fuse block but i cant figure out where. I need to know where to hook it up at. Can you help?
So I left my lights on today and it drained my battery almost entirely. I went to jump start the...
(More)
So I left my lights on today and it drained my battery almost entirely. I went to jump start the car, hooked up the jumper cables correctly to another running car, and my car won't start. I think the problem is that my alarm is activated, so when I turn the key, it doesn't do anything. It won't even try to start. But when i push the button on the pad to deactivate it, even with the jumper cables hooked up, it won't respond. i don't know what to do because I can't seem to disable the alarm system because my car is dead, but I can't start the car because the alarm is preventing the engine from reacting when i stick the key in. Does anyone know what to do? This is an after-factor alarm installment. I have a 2001 Honda Civic but Honda did not install this alarm.