Question about 1994 Chrysler Concorde

1 Answer

Tranny 94 concorde 3.5 litre won't shift from 3rd gear to overdrive

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 979 Answers

Did this car come with this engine from the MFGR? The problem could be caused by a number of things; First, make sure fluid level is correct. It is always checked on level ground with the engine running.
Next, make sure the linkage is adjusted properly. (Run over anything lately?)
Make sure that there are no codes written from the Body Control Module. Many times, if a code is written, it will cause the "check engine" light to come on. If this is the case, it leads us to the last possibility, and that's a bad torque converter or the connections going to it. Good luck with this project...accordianman

Posted on Nov 05, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why will my 94 Buick Regal run fine in 2nd and 3rd gear but not when I shift into overdrive?


You are lugging the engine. Overdrive is only for use in top gear when you get to cruising speed to reduce the engine speed.

Sep 11, 2014 | Buick Regal Cars & Trucks

1 Answer

Will not shift out of 2nd gear


Tranny most likely shot. I believe yours is a T-5, I had the same issue years back but in 3rd gear. Usually the clutch going out is a gradual thing. So I would have a tranny shop look at it. Maybe find a cheap rebuilt tranny for ya.Look online or a trusted shop.

Mar 23, 2014 | 1994 Ford Mustang

1 Answer

My 1993merc grand marquis 3 speed over drive tranny shudders shifting from 2nd to 3rd,fluid level is good overdrive off,would a fluid and filter change help?


I think you have a four speed electronic overdrive like my 94 merc.

I never had problems but I changed filter and fluid and added Lucas Oil Products - Transmission Additive 24 oz do not over fill.

Feb 02, 2014 | 1993 Mercury Grand Marquis

1 Answer

Transmission is apparently locked in 3rd gear. Gear shifter will not move.


unhook lincage at tranny and try shifting it unhocked if it shifts it inthe linckage someware cable or shift lever most likley linckage if it dont move at tranny its in the tranny

Apr 04, 2011 | 2000 Chrysler Concorde

2 Answers

Ford Ranger 98'Splash don't shift 3rd and


you will need to connect it ti a scanner to confirm but it sounds like your solenoid (there is a solenoid that controls those gears inside your tranny) the part is actually cheap and should take no time to replace. the cost comes in a way of replacing the tranny fluid that will be lost.

Apr 07, 2010 | 1998 Ford Ranger SuperCab

1 Answer

94 Chrysler Concorde Tranny Problems


Have your transmission oil filter changed;
it is located under the transmission pan
The oil is what makes the transmission shift
When you shut off the engine it stops the transmission pump then when you start up again the transmission shifts until the filter clogs again

May 28, 2009 | 1994 Chrysler Concorde

1 Answer

1990 f150 transmission up shift to early


Sounds like the passing gear cable is out of adjustment. Get a shop manual and see what the specs are on how to adjust it properly. It is a pretty simple fix.

May 27, 2009 | 1990 Ford F150

3 Answers

4L60E Shifts fine in 1st, 2nd, & 3rd but will not shift into OD


check fluid conditon and level, may be a faulty soleniod

Apr 24, 2009 | 1994 Chevrolet C1500

1 Answer

1996 3500 TRUCK WON'T SHIFT OUT OF SECOND INTO 3RD OR OVERDRIVE


Their are a few possible causes of this. One their is not enough tranny fluid in it or the kick down cable is not hooked up properly. the kick down cable also runs the vacume to the transmission.

Check theese and give me feed back to further assist you.

Thanks, Charlie

Jan 29, 2009 | 1996 Chevrolet C/K 3500

3 Answers

97 concorde with 3.5 engine @ 40 to 45 mph it starts bucking .


Computer firmware needs upgrade

Take your car to a Chrysler dealer shop and have them update the transmission program.As your tranny wears it loses it shift point and stutters between 40 - 45 mph looking for the right gear to change to..Had same problem in 94 Concorde and 94 T&C minivan.Reprogramming tranny fixed both cars.

Nov 22, 2008 | 1997 Chrysler Concorde

Not finding what you are looking for?
1994 Chrysler Concorde Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...