Washer fluid My washer fluids only sprays so far, not far at all, It does not go all the way up the windshield. The hoses are not clog. Its like the wiper are to long. blocking it path. Any suggestion

Spencer - the washer fluid pump is fed off the same fuse as the windshield wiper, i.e., #22 which is a 30 amp fuse. If the wipers work, the fuse is fine...could be another issue

What is the problem you are facing? Are you not getting any fluid spray from the nozzle? Could be a clogged hose, broken washer fluid pump or switch...

I recommend taking these steps, as I saw from another F150 site:
Open hood
** Locate washer fluid bottle
** Find the rubber hose near the bottom coming off of it
** Follow hose up to near firewall and find a connector
** Take hose off connector and point away from yourself
** Have someone power on the truck
** Press spray button
** If fluid then pump is working problem is after the connector near the sprayers
** If no Fluid then either the Pump is bad or the switch is bad.

Check fuses or washer pump. .replace.

1. check your windshield washer fluid level.
2. make sure you can hear the fluid pump operating when you operate the switch.
3. If you can hear the pump working and you have fluid in the reservoir but still no spray,
   
4. check the washer fluid lines don't have holes and aren't clogged or pinched. check the sprayer nozzles make sure they are not clogged with debris.
5. if your washer still doesn't work your fluid pump is probably the problem.
   

sounds like the spray nozzles are clogged you can usually remove them and soak them in soapy water or spray water through it with a sprayer on the end of a hose. if that doesn't solve it then you may have a cracked line or the pump that pumps it out may be broken but usually is the nozzles are clogged.

Check the rubber hoses to the sprayers. If they are on the hood they can come unplugged when you open it. Have a friend work the sprayers as you watch for leaks. An old toothbrush can be used to clean spray nozzles by scrubbing over the hole.

CHECK WIPER FLUID LEVEL FIRST ALL IS GOOD CHECK FOR POWER AT WIPER WASHER PUMP MOTOR.IF NO POWER AT WIPER WASHER MOTOR.CHECK 15 AMP FUSE IN THE ENGINE COMPARTMENT FUSE RELAY BOX.IF YES YOU ARE GETTING POWER AT WIPER WASHER MOTOR.WIPER WASHER MOTOR FAULTY.

First try to clean out the squirter nozzles.Take a very small wire, sometimes a staple works great, and stick it into the nozzle to clear any debris.Then try to spray it again.If this didn't solve the problem and the debris is cleared, then you either have a weak or blocked pump, which is located on the washer reservoir itself.Hope I could help!!! Rate me accordingly!! Thanks!

Those little nubs on your hood or the spray jets on the wipers those spray jets need to be adjusted and be pointed up you can use a sewing needle just don't jam them or break them.

follow the windshield spray nasal water lie to the pump making sure the line is not broken, next do you hear the pump running when you spay the fluid, if not that the pump is faulty, if you do hear the pump running, more likely the windshield spray nasal is clog with debris; to unclog it try to use a clothes needle, poke around in it to see if you can clear the blockage, if not, replace will be the best idea, fairly cheap and easy to replace. those windshield tank and the pump does not have good filter on them and they tend to get clog up in the pump or the spray nasal.