What color are the rear door speaker wires after the factory amp? which one of the plugs on the amp (09387426) are in and which are outgoing?
SOURCE: how do i remove the front and rear door panels on
First unlock the door. look at the door lock, you can see a little tab like that you can pull out. Do this and pull the door lock cap off. Next, behind the door handle is a cover you just pull off buy putting that flat edge of a butter or something behind it and pulling out. It is only held in with velcrow. Next, take out the screw behind that plate. Now all you have to do is run along the bottom of the door and pull it straight out until it is loose. Then pick the door straight up and off.
SOURCE: need color code diagram for factory 8 speaker
On my 99 4 door the factory amp is powered by a hot pink wire in the truck harness. I hooked the cont. power for a motorized ant. to it and all 4 speakers work. I'm going to check today to see if they work correctly because I found this out late last night and only had it on for a few minutes. I've read that there is a harness for this that apparently you have to specifically ask for at a car audio shop. hope this helps.
SOURCE: how to remove front and
go to auto parts store or retail store to get a tool called panel popper. it has 2 prongs shaped like a wrench on a shaft (like a screw driver). check panel for screws to remove and after remove screws, use panel popper to pry the panel up. put the panel popper near the plastic tabs that hold the door in place.
SOURCE: 1997 cadillac deville 4 door sedan can you replace
You can, but they won't adjust like your factory ones (automatically) Lots of folks replace w/aftermarket shocks instead of depending on factory units.
507 views
Usually answered in minutes!
×