Question about 1995 GMC Jimmy

1 Answer

Power seats pulled seat and supplied power to seat works fine.Does this yr. have a modual or brain?FOUND NOTHING IN FUSE BOX SAYING POWER SEAT,also checked both power ***.relays ok

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 58 Answers

Pull the carpet up right under the where your feet would set and look for corroded splices in the wiring harness, should be a splice with orange wires going to it. Repair the splice and check the ground splice and all should be okay.

Posted on Nov 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Drivers power seat does not work and stopped working with the seat too far forward


When the seat is adjusted to the stop it can destroy the fuse, though sometimes it is nothing more than the supply wiring plug being pulled from it's mating part. Most electric seats can be adjusted manually if the power fails. The vehicle owner's handbook should tell you how.

I suggest you wind it away from the stop before checking the fuses and replacing as necessary. If you find nothing or that doesn't work further investigation will be needed.

Feb 05, 2016 | Seat Cars & Trucks

1 Answer

I can't find the fuse box in my 03 Isuzu ascender. book say rear seat under. there is no way to get under the rug. the 2 roll there a box under seat that we can get open w/out removing the whole seat.


There are 2 fuse boxes. One in the engine compartment right next to the battery. The other one is indeed under the seat. You must pull the fabric tab in the middle of the seat and pull it towards the drivers seat. The entire seat bottom will lift up towards the drivers seat. Your rear seats fold down if you didn't know that already, seat and back rest both.

Apr 20, 2015 | Isuzu Cars & Trucks

1 Answer

2005 ford focus zx4 fuze diagram/ fuze diagram


No fuse? Or no slots? If 53 has little metal terminals inside the slots to accept a fuse, then fuse it! Someone pulled it out and put it into 52. If there was a previous owner who blew his heated seat fuse, maybe he traded his back-up lights for a cozy heated seat!
If, however, #53 has nothing there, like just an empty place of the fuse box-not wired, then indeed, strange. Is that the owner's manual you referred to? That should be accurate, if it's the owner's manual. Look closely at that #53
Good luck..

Jun 27, 2012 | 2005 Ford Focus ZX4

1 Answer

How do you replace the power seat circuit breaker on a 1996 nissan maxima?


There is a fuse box located under the dash on the right or left hand drivers side. Sometimes they even stick them in the glove box. Once you find the fuse box then on the cover or underneath the cover should be a diagram of the fuses installed and what they go to. For instance, your seats might say just that SEATS If not then just pull one fuse at a time and replace it in the same spot if good. You can tell if the fuse is bad by looking at the wire inside the fuse. It should be a solid one piece wire. if you see that it has a break or blck or melting then replace it with same amp fuse. the amps are on the fuse. Some times when a fuse blows it takes more then one with it. Go ahead and check them all to be sure.
Once done replace the cover. Please remember to give me a thumbs up for trying at my end. if you found no bad fuses then we can look into the seat moving switch. Keep me informed, Raz

Apr 19, 2010 | 1996 Nissan Maxima

3 Answers

Front seat not moving front to back for Toyota Avalon 1997


If it is power seat electric motor is faulty. For mechanical you need to spray the rails under the seat. There is the grease at any autostore or Walmart for unscrewing rusty bolts. It will be helpfull.After you do thet push seat forward and back afterwards.
It will go
Good Luck

Mar 25, 2009 | 1997 Toyota Avalon

1 Answer

Need to fine the fuse for driver seat


Hi fuse f 70 30amp green for right hand power seat switches. i would say in the passenger side fuse box, left side of car . D

Mar 05, 2009 | 2002 Jaguar X-Type

1 Answer

Seat Belts/Front Seats


seats use heavy corrent & use relays instead of fuses. check relays in fuse panel. see chart on cover or owner manual for location.

Also, this is for 96 villager seats.

Circuit Protection
Power is supplied to the seat motors through the 30A POWER WINDOW fuse. The fuse is located in the LH engine compartment fuse junction panel and is hot at all times. The circuit breaker is behind the interior fuse junction panel and prevents current overload and component damage.

go to this site for more help

http://autos.groups.yahoo.com/group/villagerquest/

Aug 24, 2008 | 1994 Mercury Villager

1 Answer

My driver side power seats and side power mirrors don't work!


sounds like a bad fuse, have a look at your manual and see which fuse controls those parts, they are most likely on the same fuse, the fuse box may also say which fuse is for what, If the fuse in the first box doesn't fix it, try a new fuse in the box under the hood, let me know how this goes, you may also have corrosion in a wire but check the fuses first.

Jul 01, 2008 | 2003 Ford Windstar

1 Answer

Power seat


I have a 1995 Jimmy and the power seats didn't work. I put my own power wire with a fuse between the seat and the live wire under dash. It works fine.

Jun 22, 2008 | 1995 GMC Jimmy

Not finding what you are looking for?
1995 GMC Jimmy Logo

Related Topics:

252 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...