Question about 1993 Subaru Legacy

1 Answer

How to change the furl pump ?

I have the gas tank disconnected but I can't get it free. What steps do I take to drop the tank properly?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

You 1st have to disconnect the hoover then ask some girl to help you drop the tank then you pull out your ***** is attack her - Your MoM

Posted on Oct 05, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change my fuel pump for a 99 Pontiac Bonneville See where is it located


its in the fuel tank. you will have to drop the gas tank to change it. support car, disconnect fuel and vacuum lines to tank, disconnect fuel filler tube(hose you put gas into car), disconnect the electrical connections, support fuel tank, undo the fuel tank straps and lower fuel tank, clean area around fuel tank unit, remove the unit lock ring and pull out unit, follow the instructions that come with the new fuel pump and re-assemble in reverse order, replace the fuel filter at the same time.

Mar 19, 2015 | Pontiac Cars & Trucks

2 Answers

How to replace fuel pump and fuel filter ?


the fuel pump is in your gas tank. make sure all of or most of the gas is out before you drop the tank. the tank is held on by two straps. once you drop it you will have to disconnect the fuel lines and electrical connections to completely separate it from the vehicle. the fuel filter is simple and is held on by two bolts. just follow your fuel line from your fuel pump and you'll find it. make sure to depressurize the fuel system before changing the filter. also make sure your battery is disconnected before changing the fuel pump.

Jul 03, 2014 | 1997 Jeep Grand Cherokee

1 Answer

Need to change fuel pump.need to know what steps to take first. believe gas tank must be dropped. just want to make sure when tank is ready to drop all other connections or screws and bolts have been...


first you disconnect the battery , chock the wheels , jack the car up use jack stands , disconnect lines and filler hose and electrical plug sometimes you have to lower tank slowly to get enough room to disconnect lines from top of tank then lower it slowly to the ground make sure you bench test the new pump before you install it sometimes you get a bad one that is stuck its better to find out before you install it hope this helps

Jul 31, 2010 | 1994 Oldsmobile Cutlass Ciera

1 Answer

Where is the access panel for the fuel pump


There is no access panel for the fuel pump- You have to drop the tank to get at it!

1. Syphon any gas from the tank

2. Prop the gas tank with a support

3. Loosen the tank straps and fill hose strap then disconnect the straps on one side

3. Drop the tank

4. Disconnect the fuel lines and wiring harness

5. Pull the tank from under the vehicle, turn the pump seal counter clockwise then remove the pump- Careful not to damage the O-ring gasket as you may need to use it again because the new gasket may not fit properly

Install in reverse order

Apr 05, 2010 | 2004 Chrysler PT Cruiser

1 Answer

How do i replace the fuel pump in my 1998 mazda 626 LTD through the back sets or do i have to take the tank out


You will definately have to drop the tank. Remove gas cap to relieve pressure, then remove gas lines, gas straps, remove bolts, lower tank. Use only a BRASS punch and hammer and knock ring loose counter clockwise, then pump and sending unit will pull out. and you can disconnect and change your pump.

go to autzone.com and register for full free online repair manual

Oct 01, 2009 | 1998 Mazda 626

2 Answers

How do I Install a fuel pump


Disconnect negative battery cable, then open gas cap to relieve fuel pressure. Then remove harness on fuel tank. Remove bolts to fuel filler tube. Remove gas lines. Remove support strap. Then with tranny jack and a helper, remove gas tank support bolts and lower tank.

Now on top of tank you will see the cap. You will need to use ONLY BRASS punch and hammer and knock the ring loose counter clockwise until it unscrews. Now sending unit and pump can be pulled out.

If this is not detailed enough for you. You can go to AUTOZONE.COM and register for free. It is a complete online repair manual for free on your entire vehicle and will also explain fuel pump removal and sometimes have diagrams.

Jul 10, 2009 | 2001 Pontiac Grand Am SE

1 Answer

94 mitsbushi eclipse


The (nots) you referred to, I assume you mean the fuel inlet and return lines on the pump itself. The tank should have a couple of straps on the bottom of the tank that most likely are secured with a couple of bolts and then you have your Fill tube that runs from the outside of the car where you pump gas into the tank that will need to be disconnected. The power connections to the pump should also be disconnected. Be careful :D

Jun 06, 2009 | 1994 Mitsubishi Eclipse

1 Answer

How do I change out the fuel pump in 1991 olds bravada


Disconnect and remove battery, than open gas tank cap, remove cap and to relieve tank pressure. From underneath the car, remove electrical plug-ins and gas lines. Now remove filler tube end from tank. Now place tranny jack or have a helper drop the tank.
Once tank is on the ground and away from vehicle, use a BRASS PUNCH ONLY! and a hammer and knock the metal ring counter clockwise until it is free. Now you can pull out pump for replacement.
Reverse procedure to re-install.

Mar 16, 2009 | 1991 Oldsmobile Bravada

1 Answer

1996 chevy suburban maybe fuel pump problems


yes it's in the fuel tank....................Drop the tank and the rest is easy.
Getting the Gas out before dropping the tank can prove to be a pain but after that is done the rest is easy.(best to run it a empty as possible) Two straps hang the tank. Remove the strap bolts and the tank will come undone. Remove the filler hoses, disconnect the power leads and the fuel lines and the tank is free. The pump comes out by twisting a ring.then remove the pump and replace then reverse the earlier steps to reinstall

Jan 07, 2009 | 1987 Honda Accord

2 Answers

1999 Dodge Ram 1500 Extended Cab 4x4


YOU'RE GONNA HATE THIS BUT IT DOES SOUND LIKE A FUEL ISSUE. HOWEVER HERE'S THE CATCH.....THE FURL FILTER IS IN THE GAS TANK CONNECTED TO THE FUEL PUMP. YOU HAVE TO DROP THE TANK OR TAKE THE BED OFF TO GET TO IT. AND YOU CAN ONLY GET THE NEW FILTER AT THE DEALER. THE LOCAL PARTS STORE DOESN'T CARRY THESE. BUT I'M NOT SURE ABOUT NAPA, THEY MIGHT. YOU MIGHT ALSO WANT TO CHECK FOR A VAC. LEAK AROUND THE THROTTLE BODY. LASTLY WHEN WAS THE LAST TIME YOU DID ANYTHING TO THE TRANS.? MIGHT WANT TO LOOK INTO THAT.

Dec 31, 2008 | 1999 Dodge Ram

Not finding what you are looking for?
1993 Subaru Legacy Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...