Question about 1991 Dodge Stealth

Open Question

1991 twin turbo stelth rt

When i start my car it could just idle when i give it gas it would stall.after about fifteen minutes i could give it some throttle and it would run fine. i would drive it for thirty miles or so and no problems i would stop shut car off for like ten minutes and it would start right back up and drive fine.
now when i wait a few days and start it back up it will not start. it wants to start but keeps back firing and wont start i'm stumped please help! maybe bad gas?

Posted by on

  • lorddeliver Nov 24, 2008

    I have the same problem with stalling out then running fine then stalling out again. I have put new spark plugs,new spark plug wires, three new coils, new fuel filter, and it does the same thing. can you help me with this problem?
    please email me @ lorddeliverus@yahoo.com


×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Car starts, drive a mile, stalls.

try haviing your alternator checked advance auto parts can check it while its on the car and the can check the battery too. if thats not it it may stall due to a loose battery connection or a loose ground strap. if it stalls and everything turns of (electrical) it may be a connection or ground strap.

Posted on Sep 04, 2008

  • 1 Answer

SOURCE: 1997 dodge ram 1500 stalls when driving

check vacuum hose into throttle body, also clean throttle body orifices and iac. remove iac [engine off] and have someone turn key to on to see if plu8nger works. just a thought .

Posted on Dec 25, 2008

  • 139 Answers

SOURCE: no belt diagram on my car wher may i find one 1991

a dealer dodge in your area. or a good auto parts
a place like autozone they will be able to help you

Posted on Apr 13, 2009

  • 1 Answer

SOURCE: Car keeps shutting off

After extensive research I have found that in 10 out of ten cases it was the E.C.M or in other words the computer for the vehicle is faulty. You can thank dodge for this problem. What happens is they put a Temperature sensitive device in an area that gets unbelievably hot. Then the Computer overheats and shuts down. In most cases the control panel in the vehicle where the odometer is says "No Bus"
The only way to fix this problem is to put a new computer in. DO NOT buy one from the dealership they are too pricey. Get on off of Ebay. For the extremely mechanical Savy you can do what I did in my durango. I carefully cut the tape away from the main harness then marked everything and cut the harness drilled a hole through my firewall (Just be careful where you drill) fed the harness through and reconnected my computer and mounted it under the dash so when it is extremely hot here in arizona the A/C Keeps the computer cool. With this method I have NEVER had this problem happen to me.
Just don't do this if vehicle is under warranty it will violate the ciditions of the warranty. Hope this helps. I have seen this problem posted to other sites and am just trying to let everyone know what it is and How to fix it.

Posted on Apr 25, 2009

  • 972 Answers

SOURCE: 97 dodge ram no spark

then i would replace whats called the hall effect sensor its that black plastic plate you see when you take dist cap off. just pull rotor and lift up the sensor.dist cap is what holds it on.also under the sensor will be a stamped sheet metal piece that looks like the top of a castle wall. make sure its not loose on the shaft.if it is then new dist will be needed

Posted on May 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine running rich


Most likely throttle positioning sencer

May 08, 2016 | Cars & Trucks

1 Answer

1991 chevy c1500 stalling


Usually a problem with a dirty throttle body or a faulty idle air control valve. The computer controls idle speed by regulating how much air enters the intake thru the valve.

Oct 13, 2012 | 1991 Chevrolet C1500

1 Answer

1991 jaguar XJ6 4.0L Stalls


Have you checked the wire that goes to the fuel tank. I have the same issue and I have to go and jiggle the wire going to the fuel tank. I'm going to take it to see about getting that fixed.

Sep 27, 2012 | 1991 Jaguar XJ6

1 Answer

My 1991 buick lesabre will start but idles rough, and stalls if you give it gas


ck if you have adequate fuel pressure 30-40 psi. if not it may need a fuel pump and filter replaced.

Sep 06, 2010 | 1991 Buick LeSabre

1 Answer

I have a 1991 Dodge Stealth RT it stalls when u come to a stop.it idles low and the oil pressure is low.what would this be.Thanks


it is okay to go low at idle...when you hit 3-4000 rpm doe it raise back up that gauge is working!!!

May 14, 2010 | 1991 Dodge Stealth

1 Answer

Car stalled and will not start


check the ground connection for the fuel pump also check the connector

Aug 19, 2009 | 1991 Nissan 300ZX

1 Answer

Car stalls at idle


the lock up converter is staying engaged when you stop have it scanned for trans codes may need lock up selinoid (tcc) or torque converter changed try putting it in neutral before you stop if it stays running this is probibally your problem

Jul 15, 2009 | 2002 Pontiac Sunfire

4 Answers

1991 Toyota Supra


piston rings are shot and your valves need to be replaced

have you been racing this vehicle or has previous owner

if you just bought the car im sure last driver had it semi decked out now you will need a laptop the cars software to reset vehicles computer back to factory settings
when owners drive there vehicles they set them up in a way so more gas and throttle can be applied you just need to reset everything back to factory settings on comp
and if that dont work you will definatly need to do an over haul

Jun 01, 2008 | 1992 Toyota Supra

Not finding what you are looking for?
1991 Dodge Stealth Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...