Question about 2006 Chevrolet Silverado
2006 Silverado LT 4.8 L. Reduced power message on. Truck doesnt even have 30,000 m. on it yet.and is very well maintained.What can I check..? Oil press and Temp OK.
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
get a can of carb cleaner and clean the throttle flap really good with a clean rag, also clean the air sensor unit with electronic clean air can. DO NOT BLOW IT WITH A COMPRESSOR AND DO NOT RUB HARD WITH ANYTHING. if this continues the flap on the throttle body might be loose. hope this helps.
Posted on Dec 01, 2010
SOURCE: 2004 chevy silverado
The above descriptions of the connector are very good. I washed the engine compartment yesterday, and immediately started getting the reduced enginer power code on the CIC, not performance. After reading several posts, I checked the connector on my 2003 2500HD, and found that the connector was not seated well and had gotten water in it. I cleared the water and the reconnected. The cables running from the fuse box to the connector are so short, the connector is in a bind and is pulled off-center. That is why the connector wasn't seated properly. The code went away, and the performance returned. By the way, be sure to do this after pulling the negative cable on your battery.
Posted on Apr 30, 2009
SOURCE: reduced engine power
hi there my name is don i will try to help you on this
when your reduced engine light comes on that means there is a active fault code in one of the sensors that is cusing this
you will have to get it scanned or retreive the codes from the dash
once you shut it off and turn it back on it temporarly resets until the diagnostics go through it again and it will reduce the power to the engine
it could be something simple like a gas cap or tire pressure but you will have to get it scanned to find out
Posted on Aug 24, 2009
You need to have the computer scanned for trouble codes. Whatever happened stopped after you restarted the engine, but the engine light wont go off until the ignition cycles many times without any problems. Any parts store will scan your truck for free. Have them scan it and clear the codes, and come back here and let us know what code/s you get.
Posted on May 16, 2010
SOURCE: reduced flow to EGR valve
the 1st thing to do is pull the valve off and inspect the passages the gases flow through for carbon, u will find they are plugged, use a wire brush or a coat hangar to clean this carbon out.
Posted on Oct 29, 2010
Tips for a great answer:
Apr 25, 2016 | Cars & Trucks
Nov 14, 2015 | Cars & Trucks
Oct 28, 2015 | Cars & Trucks
Dec 14, 2013 | 2006 GMC Yukon Xl Denali
Nov 22, 2010 | 2006 Chevrolet Silverado
May 16, 2010 | 2006 Chevrolet Silverado
Jan 09, 2010 | 2006 Chevrolet Cobalt
Aug 10, 2009 | 2004 Chevrolet Silverado 1500 Crew Cab
Mar 07, 2015 | 2006 Chevrolet Silverado
Jul 14, 2014 | 2006 Chevrolet Silverado
1,654 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: