Question about 1996 Jeep Grand Cherokee

1 Answer

No start went to start engine it fired up but was popping and back firing would not rev to 2000rpm to start lpg. Engine cut out after 30sec or so.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 475 Answers

You very well may have a bad or disconnected map sensor.

Posted on Oct 06, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lpg car


Wonder if it has a safety switch that requires engine pulses. Had a similar problem with my lpg car was wrong mixture would take like twenty attempts to start the car.

May 05, 2014 | 1993 Nissan Sentra 4 Door

1 Answer

2000 vt comm dual fuel has started back firing engine ceases and wont start till a few minutes have passed This happens on lpg and petrol but is more inclined to start again on petrol Any ideas


the fuel contoller may have blocked or failed. have you ever replaced the lpg filters?
take your vehicle to a garage who can repair and test lpg.
this will be far cheaper than guessing.
Roger

Apr 26, 2014 | Cars & Trucks

1 Answer

Engine wont rev above 2000rpm


If you have a hih miles truck,it is very possoble you have aclogged cat.Have a muffler shop test pressure in front and behind by drilling small holes,checkin w/gauge,then welding back.This should be free if you replace the cat.

Mar 23, 2014 | 2002 Ford Expedition

1 Answer

1993 festiva replaced the throttle body gasket now will not accelerate at temp


I have a 1997 ford E 150 customize mark 3 van have driven back and forth to work 5 years ran great Christmas Day drove down to the garage and back up to house and now it will not start turns over has spark will not fire

Jan 07, 2014 | 1993 Ford Festiva

1 Answer

My 94 Chevy c1500 v6 pickup truck is having issues with firing. 1. it started miss fire ( startes up fine but while its running I hear a pop and right then the motor sounds like it was cutting out, but...


The only thing I know of, on a gasoline engine, that will bite you is secondary ignition voltage. What about your ignition coil? If the vehicle will run, raise the hood in the dark, look for fire/spark jumping around.

Apr 28, 2017 | 1994 Chevrolet C1500

2 Answers

Golf mk 4 gti turbo starts up but wont rev past 2000rpm


turbo is malfunctioning the turbo waste gate is not working take it to a shop right away, preferablly tow it so as not to damage the engine, if the exhaust gas's gets near the turbine bearings you will burn up the engine and the turbo cna explode like a hand granade and destrou your enging.

Jul 21, 2009 | 1999 Volkswagen GTI

1 Answer

Airbox went Boom!


Sounds like it back fired.
Which fuels are you using?
This may have happened because the engine was too hot for the gas. Be sure to let the engine cool down before switching next time.
As for repairs you will most likely just need an air filter, air box, and maybe as mass air flow sensor.

Jun 27, 2009 | 1999 Land Rover Discovery

2 Answers

Sluggish loss of power and popping noises from engine


Clean the distributer cap in the inside, it has water in it thus causing all the noises and the back fire.

Jun 20, 2009 | 1994 Volkswagen Golf

1 Answer

Back-fires and cuts off


check the distributor to make sure that the rotor is pointing at the no. 1 cylinder when that cylinder is at top dead center on the compression stroke. It sounds like your distributor rotor is 180 degrees out of time. The engine will run but will do what yours is doing.

Jan 30, 2009 | 1987 Toyota Corolla 2 Door

1 Answer

318ti M44 acceleration problem


Have someone handy to press the gas pedal for you after the engine has warmed up well; best if driven.

While you listen at the exhaust pipe, have your helper increase the revs slowly and note whether the exhaust note changes to a hiss, instead of the sound of an engine firing.

You may have a decayed catalytic convertor and when they come apart inside, they can clog mufflers and resonators (the second, smaller muffler).

I've had this happen on more than one car and when it happened on a Fiat Strada years ago, since the routing of the system was fairly straight and made of heavier gauge stainless steel, I fired two shots with a .357 magnum into the tailpipe.
Never had another problem with it.

Jul 15, 2008 | 1996 BMW 318

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

71231 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7001 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...