Question about 1986 Ford Bronco

1 Answer

1986 FOR BRONCO II v-6 ENGINE 4 WHEEL DRIVE AUTOMATIC 2.9 LITER

STARTS UP FINE, ITILES OK, BUT WHEN YOU START OUT IT BEGINS TO
TO BOG DOWN, LIKE ITS NOT GETTING ENOUGH GAS. WHEN YOU PUT IOT IN NEUTRAL AND PUSH ******* THE GAS, IT WILL STRAIGHTEN OUT, BUT AS SOON AS IT GOES BACK INTO DRIVE IT STARTS AGAIN. WE HAVE USED FUEL INJECTOR CLEANER, REPLACED FUEL FILTER, PLUGS. NEW REBUILT TRANS.
PLEASE HELP!

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 92 Answers

LOCATE EGR VALVE,, BELOW HOUSING, THIER ARE OPENINGS GENTLY, USING FINGER, INSERT IN OPENING, PUSHUP ON DIAGHRAM, WHEN YOU RELEASE FINGER IT SHOULD RESEAT AND SEAL,LISTEN TO ENGINE OPERATERTION FOR VARIATION TO IDLE, YOU HAVE JUST CHECKED TO MAKE SURE DIAGHRAM IS NOT BAD, NEXT CHECK VACMN TO VALVE,AND CONDITION OF HOSE.

Posted on Oct 05, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to get the right fuel pump relay for 1988 ford bronco 2 xlt can't see numbers on it. 4 wheel drive manual trans. 2.9 v/6 engine


Call the parts stores.

Call more than one to check prices.

Don't let them try to rip you off.

Nov 07, 2010 | 1988 Ford Bronco II

2 Answers

2001 chevy monte carlo 3.8 liter v-6: starts fine


is your check engine light on ? if not check the fuel filter it may be plugged. it is also possible that your fuel pressure is low, is it start it then it bogs and dies, for you may have a defective idle air mixture solenoid, this will not call up a code there for no check engine light, hope this helps , let me know good luck

Jan 28, 2010 | 2001 Chevrolet Monte Carlo

4 Answers

What is the firing order for a 1984 ford bronco 2


1-4-2-5-3-6
Now you need to know which cylinder is which. If you stand at the front of the truck looking at the engine, the number 1 cylinder is on the left closest to you. The left bank has cylinders 1-3-5 and the right bank has 2-4-6. So number 1 is at the left front and number 6 is at the right rear.

Jan 25, 2010 | 1984 Ford Bronco II

1 Answer

I have an 1988 ford bronco 2 automatic V6 i pulled


There are shift solenoids in the transmission and apparently there's a problem them. I would get it to a trany shop and have it checked right away. If you continue to drive it you will ruin the transmission. Are sure you put the right computer in the vehicle? If you put a computer from a Bronco II with a manual trans in a vehicle with an automatic trans, the trans won't work right.

Jan 22, 2010 | 1988 Ford Bronco

1 Answer

Where is the fuel pump on a 1986 ford bronco II v-6 fuel injected engine


the pump is on the top of the fuel tank and goes down inside the tank from there.

you have to drop the tank to get to the fuel pump.

Jan 11, 2010 | 1986 Ford Bronco II

1 Answer

I had a serious wiring meltdown under the hood of my 1986 Bronco 2.(2.9 liter engine).I need schematics for the electrical system.Please help. The problem started with a direct short on the hot wire coming...


get your self a book and the n start troble shooting then if you can't figuar it out start wiring it ur self but dont use the wrong gadge of wire and amprage rating

Apr 05, 2009 | 1986 Ford Bronco II

1 Answer

I have a 1990 ford bronco 2 2.8 liter efi automatic. it will start and drive but not over 45 and sputters the whole drive. wats wrong?


Could have a clogged catalitic converter,you could drop the pipe at the exhaust manifold and try driving it a short distance and see if it is better.

Mar 29, 2009 | 1990 Ford Bronco II

1 Answer

88 Bronco ii won't shift into 4 wheel drive.


Check to see if you are getting power through your switch on your dash. I also suspect your shift motor but it is a lot easier to check it with a test light.

Jul 01, 2008 | 1988 Ford Bronco II

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...