My 2010 ranger idles fine when cold, but cuts out when idling warm

2004 Ford Explorer Engine Stalls/Cuts Out While Driving: 31 ...

www.carcomplaints.com/Ford/Explorer/.../engine/engine_stalls_cuts_out...

... 2013 · 2012 · 2011 · 2010 · 2009 · 2008 · 2007 · 2006 · 2005 · 2003 · 2002 · 2001 · 2000 ... 2004 Ford Explorer engine problems: engine stalls/cuts out while driving ...to overheat and slide out of its socket, causing the engine to shut off. ..... Suddenlyat 30-35mph, my engine just died and i cannot control the steering wheel.

2005 Ford Escape Engine Shutdown While Driving: 24 ...

www.carcomplaints.com/Ford/.../engine/engine_shutdown_while_drivin...

The 2005 Ford Escape has 24 complaints for engine shutdown while driving. ...January 22: Ford Ranger Driver Killed by Takata Airbag in South Carolina news ' 2 days ago; Ford Focus Door Latch ..... I was 80 miles from home when the engine shut off. .... No one could seem to determine the true cause of the problems.

Ford Ranger Stalling/Dying Problems - Edmunds.com

forums.edmunds.com > Ford > Ford Ranger

Nov 2, 2007 - 31 posts - ‎21 authors
Learn more about Ford Ranger at the Edmunds.com Car Forums! ... cut off a couple of times then it started happening more frequent while driving. ..... the other day I was driving down the highway and it just shut off, no warning .... 2000. when it gets overheated the circuit shorts and causes the engine to die. Ford Expedition engine cutting off while driving
31 posts
Oct 24, 2009
Mercury Mountaineer Start Stall Idle Problems
31 posts
Oct 1, 2007
More results from forums.edmunds.com

Could be crank shaft sensor.

any engine check light on ?
could be the idle control sensor

You have sensors which controls the idle, check which sensor is at fault and replace it, the light could come on from different sensors, so please replace all the bad sensors, and you will be fine.
Good Luck

idle stop screw may be out of adjustment or idle air control not working as it should (iac) valve pass side of tbi slightly to the rear

Watch your temp gauge while this happens, does it stay stationary? This sounds like it could be a thermostat problem.

Tune up?

if u have a damaged plug it can be running on 1 less cylinder ,it will idle very rough,change it!

To update my earlier repair on the 2001 6 cyl Escape: When cold, and when the ignition was turned over but no accelerator pressure given, the rough idle finally returned the P0303 code again when the check engine light came on indicating that it wasn't caused by the plugs or the coil. FYI, I had replaced the intake manifold gaskets during the original repair and just prior to that I had replaced the fuel filter which was very dirty (I cut it open to see).

The repair manual referred to fuel injectors as a possible problem. I have run three tanks of fuel using different injector cleaning products and am very pleased with the results. Cold starts are much smoother and I am unable to coax out the P0303 code or any other code.

My opinion, change the fuel filter, use a fuel injector cleaner for a couple of tanks, change the plugs if the problem still exists. The coils were not the problem on my vehicle.

try changing your egr valve first