Need to locate thermostate un 2002 buick rendevous

3.4L Engine

1. Remove the air cleaner and duct assembly.
   
2. Drain the coolant until the coolant level is below the thermostat.
   
3. Remove the crossover exhaust pipe.
   
4. Remove the radiator hose from the thermostat housing.
5. Remove the thermostat housing bolts and clean any sealer from the bolt threads.
6. Remove the thermostat housing and gasket.
   
7. Remove the thermostat.
   
8. Clean the mating surfaces.

Fig. Remove the housing bolts - Image Zoom Link

Fig. The removal and installation of the thermostat Image Zoom Link

1. Install the thermostat.
   
2. Install the thermostat housing and gasket.
   NOTE Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
   
3. Install the thermostat housing bolts and tighten them to 18 ft. lbs. (25 Nm).
   
4. Install the radiator hose to the thermostat housing.
   
5. Install the crossover exhaust pipe.
   
6. Install the air cleaner and duct assembly.
   
7. Fill the cooling system.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day and Merry X-mas.