- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There is a possibility that your key fob might lost the programming. I suggest that you re-program your key fob, follow the next steps to re-program it.
Sit in the vehicle and close all the doors. Insert the key into the ignition.
Turn the key to the "Off" position then to the "On" position. Repeat this until the door locks cycle to indicate that the programming mode is activated. End with the ignition key in the "On" position.
Press the "Unlock" or "Lock" button on the programmable remote. Listen for the doors to lock or unlock to verify successful programming.
Turn the ignition key to the "Off" position. Listen for the door locks to cycle to indicate that you have exited the programming mode.
Repeat the above steps to add any additional remotes.
Just had the same problem and know it is fixed.
You may have worked out that you can use the fob to unlock and then immediately lift the passenger handle to get access- not ideal.
In my case I couldn't turn the key in the drivers door either
1, Remove the 25 AMP fuse for door locking from fuse box under the bonnet. This disables central locking. The passenger door opens fine. The key however won't turn in drivers door.
2, Spray WD40 or other moisture repellent protective lubricant on key. Insert into drivers lock- gently turn back and forth. Half remove key so you can spray more WD40 into lock- a good blast will do. Keep gently turning until you can lock and unlock.
3, Replace 25 amp fuse
4, Hopefully job done- worked for me
Sounds like they disconnected your battery when they were working on your car. Your radio probably requires an unlock code to get it to work again which you'll have to get from a dealership with proof that the car is yours.
They key fob will also have to be reset.
Close all the vehicle doors.
Insert the ignition key into the ignition lock cylinder.
Press and hold the door unlock switch.
While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
Press and hold the LOCK button and the UNLOCK button simultaneously
on one transmitter. After a delay of approximately 15 seconds, the
doors will lock and unlock to confirm the programming of that
Turn the ignition switch to the On position in order to exit the keyless entry transmitter programming mode.
Operate the transmitter functions in order to verify correct system operation.
get in your car close door hit the unlock button then put key in the ignition cycle the key from off to on (STOP BEFORE START POSITION) cycle key off to on 7 times after the 7th trime the doors should lock the unlock automatically that means u are in trainning mode hit the unlock button on key fob. the key fob should now work if it doesn't then try changing batt