Question about 2002 Ford Windstar Cargo

1 Answer

Oxygen sensors Where can I find the the oxygen sensor on the exhaust manifold on a 2002 Ford Windstar SE????????

Posted by on

  • greykara Jan 12, 2009

    Thank you! I found out that I have 4 oxygen sensors and I have had them all replaced. Now my problem is that the engine light has come back on and I have been told that it is a vacuum leak from my power brake booster. Also, now my front heater/defroster isn't working, all I get is cold air but the back is working fine. Now what do I do? I wish I were a man and knew how to fix these things.....driving me nuts!!

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 4,369 Answers

You have 3, 2 upstream and one downstream. They have wire harnesses attached to them and they screw into the exhaust system. Ususally two in the exgaust crossover pipe, the other just behind the catalytic converter.

Posted on Jan 12, 2009

6 Suggested Answers

  • 133 Answers

SOURCE: Jaquar X Type Oxygen Sensor

two at the front on the exhaust cat and two on the rear, and yes if there tight

Posted on Dec 31, 2008

alicantecoli
  • 21949 Answers

SOURCE: change oxygen sensor 2001 ford windstar

fist unclip wire,then unscrew it with a 28mm spanner ,fitting procedure is the reverse .It turns anticlockwise to unscrew and clockwise to screw up ,torque setting is a grunt and two scuffed knuckles and max of 3 swear words

Posted on Jan 01, 2009

  • 66 Answers

SOURCE: 2002 Ford Windstar Oxy Sensors

There are issues with upper/lower intake gaskets on this engine. Also make sure you don't have a tube disconnected from the air intake between the air filter box and thottle body. If everything is connected, I would be renewing the upper/lower intake gaskets. This will cause lean codes to be set, and you may have noticed a ratty idle on cold start-up. Hope this helps. Good Luck and please leave rating. Thanks

Posted on Jan 05, 2009

djicenova
  • 319 Answers

SOURCE: were is the front oxygen sensor located on a 1996 lincoln tow car

passenger side of manifold, before the catalytic converter. this system may have more than one on the frontside of the cat.

Posted on Feb 27, 2009

  • 323 Answers

SOURCE: how to replace an oxygen sensor bank 1 and exhaust gas recirculation sensor

The EGR valve is attached to the intake manifold near the throttle body and the 1/1 O2 sensor is on the rear exhaust manifold.

Posted on May 02, 2009

ZJLimited
  • 17970 Answers

SOURCE: where is the rear "b2

Oxygen sensors are always numbered like this:
Bank 1 sensor 1
Bank 2 sensor 1
Bank 1 sensor 2
Bank 2 sensor 2

Some manufacturers use a kind of shorthand that reads different, but means the same thing:
Sensor 1/1 or O2s 1/1
Sensor 2/1 or O2s 2/1
Sensor 1/2 or O2s 1/2
Sensor 2/2 or O2s 2/2

Bank 1 is always the side of the engine where cylinder number 1 is located and, of coarse, Bank 2 is the opposite side.
On a 4 cylinder engine, there is only 1 bank and it is always referred to as Bank 1.

Sensor 1 is always the upstream sensor (The one located BEFORE the catalytic converter)
Sensor 2 is always the downstream sensor (the one that is located AFTER the catalytic converter.

Hope helps (remember to rate this).

Posted on Oct 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the oxygen sensors located? diagram oxygen sensors


Most are located on or near the exhaust manifold.

Sep 01, 2014 | 2002 Ford Windstar Cargo

1 Answer

2002 toyota avalon engine check light on P0078 and P007C


P0050 HO2S Heated Oxygen Sensor -Control Circuit (Bank 2 Sensor 1)

P0051 HO2S Heated Oxygen Sensor -Control Circuit Low (Bank 2 Sensor 1)

P0052 HO2S Heated Oxygen Sensor -Control Circuit High (Bank 2 Sensor 1)

P0053 HO2S Heated Oxygen Sensor -Resistance (Bank 1 Sensor 1)

P0054 HO2S Heated Oxygen Sensor -Resistance (Bank 1 Sensor 2)

P0055 HO2S Heated Oxygen Sensor -Resistance (Bank 1 Sensor 3)

P0056 HO2S Heated Oxygen Sensor -Control Circuit (Bank 2 Sensor 2)

P0057 HO2S Heated Oxygen Sensor -Control Circuit Low (Bank 2 Sensor 2)

P0058 HO2S Heated Oxygen Sensor -Control Circuit High (Bank 2 Sensor 2)

P0059 HO2S Heated Oxygen Sensor -Resistance (Bank 2 Sensor 1)

P0060 HO2S Heated Oxygen Sensor -Resistance (Bank 2 Sensor 2)

P0061 HO2S Heated Oxygen Sensor -Resistance (Bank 2 Sensor 3)

P0062 HO2S Heated Oxygen Sensor -Control Circuit (Bank 2 Sensor 3)

P0063 HO2S Heated Oxygen Sensor -Control Circuit Low (Bank 2 Sensor 3)

P0064 HO2S Heated Oxygen Sensor -Control Circuit High (Bank 2 Sensor 3)

P0065 Air Assisted Injector -Range/Performance

P0066 Air Assisted Injector -Circuit Malfunction or Circuit Low

P0067 Air Assisted Injector -Circuit High

P0068 (MAP) Manifold Absolute Pressure /(MAF) Mass Air Flow - Throttle Position

Correlation

P0069 (MAP) Manifold Absolute Pressure / (BARO)Barometric Pressure Correlation

P0070 Ambient/Outside Air Temperature Sensor -Circuit Malfunction

P0071 Ambient/Outside Air Temperature Sensor -Range/Performance Problem

P0072 Ambient/Outside Air Temperature Sensor -Circuit Low Input

P0073 Ambient/Outside Air Temperature Sensor -Circuit High Input

P0074 Ambient/Outside Air Temperature Sensor -Circuit Intermittent

P0075 Intake Valve Control Solenoid Circuit Malfunction (Bank 1)

P0076 Intake Valve Control Solenoid Circuit Low (Bank 1)

P0077 Intake Valve Control Solenoid Circuit High (Bank 1)

P0078 Exhaust Valve Control Solenoid Circuit Malfunction (Bank 1)

P0079 Exhaust Valve Control Solenoid Circuit Low (Bank 1)

P0080 Exhaust Valve Control Solenoid Circuit High (Bank 1)

P0081 Intake valve Control Solenoid Circuit Malfunction (Bank 2)

P0082 Intake Valve Control Solenoid Circuit Low (Bank 2)

P0083 Intake Valve Control Solenoid Circuit High (Bank 2)
P0084 Exhaust Valve Control Solenoid Circuit Malfunction (Bank 2)

Mar 22, 2013 | 2002 Toyota Avalon

1 Answer

Wheres the location of the number one bank oxygen censer on a ford windstar 3..8 liter 2002


bank one is always the same side of the engine as the number one cylinder. Bank two is the opposite side.

the number one cylinder is on the back side of the engine closest to the firewall. the upstream (sensor 1) O2 sensor will be in the exhaust manifold. The downstream (sensor 2) will be in the exhaust pipe after the catalytic converter.

Feb 10, 2012 | 2002 Ford Windstar Cargo

1 Answer

WHERE IS THE OXYGEN SENSOR


there are accually four two on each side the top ones are right at the exhaust manifolds the lower ones are buy the catilatic converters

Dec 25, 2011 | 2002 Ford Mustang

1 Answer

1994 ford f150 oxygen sensor location


An Oxygen Sensor (O 2 S) or heated Oxygen Sensor (HO 2 S) is used on all engines. The sensor is mounted in the right side exhaust manifold on some V8 engines, while other V8 engines use a sensor in both right and left manifolds.

Heated oxygen sensors are located in the exhaust pipes below the exhaust manifolds. The sensors react with the oxygen in the exhaust gasses and generates a voltage based on this reaction. A low voltage indicates too much oxygen or a lean condition. Where as a high voltage indicates not enough oxygen or a rich condition.

Disconnect the Oxygen Sensor (O 2 S). Measure resistance between PWR and GND (heater) terminals of the sensor. If the reading is about 6 ohms at 68°F (20°C). the sensor's heater element is okay.

Hope this helps (remember to rating this free answer).

Oct 13, 2011 | 1994 Ford F150 Styleside Supercab

1 Answer

Have a oxygen sencor and dont know were to put it in at thanks....


WELL WHICH OXYGEN YOU REPLACING THE UPSTREAM OXYGEN SENSOR MOUNTED IN EXHAUST MANIFOLD AND THE DOWN STREAM OXYGEN SENSOR LOCATED IN THE EXHAUST SYSTEM AFTER THE CATALYTIC CONVERTER .YOU NEED A OXYGEN SENSOR SOCKET TO REMOVE IT.TO REMOVE OXYGEN SENSOR CRANK VECHICLE TO GET OXYGEN SENSOR HOT BECAUSE HARD TO REMOVE WHEN COLD.BECAREFUL DONT GET BURN ON EXHAUST MANIFOLD WHEN REMOVING OXYGEN SENSOR.AND WHEN INSTALLING NEW OXYGEN SENSOR USE ANTI SEIZE COMPOUND ON SENSOR THREADS.BUT MOST OF THE TIME NEW SENSOR WILL HAVE ANTI SEIZE COMPOUND ON IT.

Dec 08, 2010 | 2002 Jaguar S-Type

1 Answer

My van has codes for bank1 sensor1 and bank 2 sensor2, how am i supposed to know which is which?


tis telling u about Oxygen sensor..bank 1 n 2 means exhaust manifold ( u have on each manifold before and after the catalytic converter.. ( ti's for 6 cyl.. very common on ford eng..(windstar..have 2 catalyctic.. O sensors is about $50 a pc..

Sep 17, 2010 | 1998 Ford Windstar

2 Answers

I need the location of a rear oxygen sensor on a 2002 windstar


It's right behind the catalytic converter on the exhaust pipe. Looks like a spark plug screwed into the pipe with wires running up into the connector.

Sep 02, 2010 | 2002 Ford Windstar Cargo

2 Answers

How many O2 sensors are on the '01 Grand Am SE V6


YOU HAVE 2 OXYGEN SENSORS.1 ABOVE THE EXHAUST MANIFOLD WHICH IS THE CRITICAL ONE AND YOU 1 OXYGEN SENSOR AFTER THE CATALYTIC CONVERTER.

Apr 30, 2010 | 2001 Pontiac Grand Am SE

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...