Question about 1988 Honda Accord 4 Door

1 Answer

Vaccum line diagram for a 1988 honda accord

I need a vaccum line diagram that i can read clearly for a 1988 honda accord.

Posted by on

  • 3 more comments 
  • yadayada
    yadayada May 11, 2010

    good luck finding that, let us know

  • Anonymous Mar 19, 2014

    need vacuum diagram

  • Anonymous Mar 19, 2014

    diagram for injected model and the carb model

  • Anonymous Mar 19, 2014

    fuel injected model

  • Anonymous Mar 27, 2014

    This car idles up and down what are posible causes theres no vaccume leaks

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 8 Answers

Http://www.pauldesign.ru/honda/shopmanual/62se320.pdf

There is a Vaccum diagram in that manuel.
make sure you are looking at the correct engine diagram
You mostlikely have the A20A3 or A4 that is the diagrams you should be looking at.
Good luck.

Posted on Nov 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Timing belt diagram for a 1988 honda accord dx


Go online, search "Honda Accord 1988 DX timing belt" and use "images". There are loads of pictures of the timing belt layout. See which is applicable to you.

Oct 20, 2014 | Cars & Trucks

1 Answer

Why does the fuel gague in my 1988 Honda accord always read full?


check to see if your fuel gauge is working by disconnecting the fuse from the panel, if gauge reads e then ground the fuel gauge if it reads full then the fuel gauge reads fine the its the float sensor in the fuel tank. good luck have fun

Oct 21, 2011 | 1988 Honda Accord 4 Door

1 Answer

1992 honda accord dx when its idleing it will rev up and down for no reason I took off a vaccume line next to throttle and it idled could this line be clogged?


yes or possibly more likely hose may be collapsing from the vaccum...inspect...also check throttle position sensor,idle control valve.mass air flow sensor, or possibly (map)sensor.any one of these could cause your problem.start with (map)sensor they are a comon trouble maker.

Mar 18, 2011 | 1992 Honda Accord

2 Answers

Iam trying to find a diagram for the vaccum lines on my 1988 daytona can you please tell me how to find this info


Hey every daytona I worked on had a vaccum diagram right on the hood. If its not there I know I have also seen them in a hynes manual

Jan 27, 2011 | 1988 Dodge Daytona

1 Answer

What is DTC code P1491? 1997 Honda Accord


hi, "EGR Valve Lift Insufficient Detected" is most often caused by a broken vacuum line going to the EGR valve. So I would check all the vaccum lines to be sure they are tight and not broken.If the vacuum lines are good, you will need to check the electronics that operate the EGR system. thanks

Oct 26, 2010 | 1997 Honda Accord

1 Answer

I have vaccum lines and I am not sure where they go to, I need a diagram showing me where all the vaccum lines go


I don't have the diagram for vacuum lines for the 1988 model year, but I have one for the 1989 model year 2.5L engine VIN E Throttle Body Injection:

85384195l.gif

Aug 03, 2010 | 1988 Chevrolet S-10

1 Answer

How to line crank and cam for timing belt on 1988 no crank marks


Hard to explain here... but I believe that car also has the balance shaft which needs to be timed as well. The camshaft has 2 lines which line up to the top of the head, and a "up" or "top" mark at the top.
Crank is set to 0 degrees.

May 02, 2010 | 1988 Honda Accord 4 Door

2 Answers

1988 Pontiac Firebird - vacuum leak


go to autozone.com, become a member(completely free and safe) and then you can access their repair guide section which contains a vacuum diagram for your 'bird....you'll use that site a lot.....need to get yourself a haynes manual for your car-.....thanks for the question...ps- also check out a forum just for firebirds....hope this helps

Mar 08, 2010 | 1988 Pontiac Firebird

1 Answer

Is there a way to repair the fuel lines in the unibody of my 1988 honda accord


Hi,

Thanks for using Fixya.

You have quite a problem here... there are currently no replacement fuel line parts for a 1988 honda accord. What you can do right now is to visit a local car junk shop and find yourself an accord of the same model. You'd probably spend alot of time doing this but this is the only way. Best wishes.

Thanks and have a nice day.

- Hotratchet

Nov 03, 2009 | 1988 Honda Accord 4 Door

1 Answer

Where can i get a clear vacuum hose diagram for a 1988 Honda Accord DX


Go to http://alldatadiy.com/ you can buy a 1 year subscription for your car. It will have all the schematics and diagrams you need.

Oct 20, 2008 | 1988 Honda Accord 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

666 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...