Question about 1999 Lincoln Town Car

Open Question

Seat belt warning light stays on

The seat belt light stays on all the time while ignition is on. have checked wireing connections under seat and all seem to be o.k.

Posted by on

6 Suggested Answers

  • 14 Answers

SOURCE: Seat belt warning light on. 01 VW Golf

More likely to be a sensor - check gsf (google it - german, sweedish, french car parts) for the seat belt sensor

Posted on Oct 13, 2008

alicantecoli
  • 21949 Answers

SOURCE: 2002 airbag warning lites stay on and flashing

have wiggle under front seats for wire that controls the sensors under the seat and move them about a bit

Posted on Jan 01, 2009

lastech
  • 408 Answers

SOURCE: srs light come on

hi,send your car to dealer to scan the problem,maybe erase fault is require ,or you can found the exact defective part,ty

Posted on Mar 25, 2009

  • 4706 Answers

SOURCE: warning light for airbag/seat belt pretensioners

Common fault on FORD
Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the passenger seat.


Just push it together properly and it should clear the AirBag fault


Posted on Sep 06, 2009

  • 89 Answers

SOURCE: airbag light stay on.after checking,the driver

go to www.vehix411.com if you can reset it or diagnose it without a computer thay will have free video instructions

Posted on Feb 04, 2010

xxCARxx
  • 76 Answers

SOURCE: what fuse do i pull

there is what they call a chime module . located on the drives side in or near the fuse box by the lower kick pannel . this module could be about 2x2 color black/green/or tan . and look like it has a small speaker grill in it . remove this and it should stop the warning chimes

Posted on Mar 06, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 town and country touring i want to disconnect the seatbelt warning light and chime?


1. Turn the ignition switch to the off position and buckle the seat belt
2. Turn the ignition switch to run (engine does not need to be running), wait for the seat belt light to turn off.
3. Within 60 seconds, unbuckle and rebuckle the drivers seat belt at least 3 times, ending with the seat belt buckled.
4. Turn the ignition key to the off position. A single chime will sound to signify that you have successfully completed the programming.

It can be reactivated by repeating these steps.

The alert will be deactivated but the warning light will continue to stay on will the belt is unfastened.

Feb 13, 2013 | 2005 Chrysler Town & Country

1 Answer

2003 ford escape seat belt warnign light


Probably no need to see an expensive mechanic. My seat belt warning light came on a few days ago when there were four people in the car and the rear seat belts weren't fastened (I thought that was why it lit up). However, the light came on and stayed on when I was the only person in the car. Logically, it suggested a bad connection somewhere, so I checked the connector under the passenger seat and made sure it was properly fastened together. I then sprayed a small amount of WD40 into the female clasps of both front seat belt connectors, clipped and unclipped the belts a few times and the light is now fine. Try it - it worked for my 2003 Escape.

Jun 03, 2012 | 2003 Ford Escape

1 Answer

The airbag light in dash staying on in my 2004


Under driver and passenger seats are wires that go to seat belt anchors.These are tensioner wires.Unplug the wires from the plug under the seat.clean and replace.Doing this while the ignition is turned off.Then turn ignition back on.In 90% of the time this is your problem.Constant movement of seat causes this or rear passengers kicking plugs off.Good luck phil.

Jul 10, 2009 | 2002 Kia Optima

5 Answers

2005 seat belt reminder keep beeping and the light keeps flashing


take wire harness apart underseat that connects to seatbelt on drivers side. then take a piece of aluminum foil and stuff it into male part so it makes contact with both prongs and plucg connection back together..problem solved!!!!!!

Jun 29, 2009 | 2004 Dodge Ram 1500

2 Answers

Seat belt light staying on


There is a small clip with one wire on it at the base of the seat belt where it connects to the floor. It might be broken, or the switch inside the belt clip is faulty. If the wire is fine and connected the belt clip side needs replacing

Mar 30, 2009 | Dodge Ram Pickup 1500 Cars & Trucks

1 Answer

2002 VW Beetle GL seatbelt warning light stays on all the time


most likely if you look under the 2 front seats and inspect the wires that come from the belt you'll find a broken wire. just repair broken wire and you'll be back in business.

Mar 24, 2009 | 2002 Volkswagen Beetle Turbo S

2 Answers

AIR BAG LIGHT STAYS ON


look to see if you can adjust your seat belt pretensioner to better suit your height. look at the top of your seat belt- ( driver's side up and to the left of your left shoulder ) and see that you can very easily slide up or down your seat belt pretensioner. you are actually supposed to do this and even redo it if you ever readjustt your seat up or down or forward or backwards. believe it or not, your safety airbag light will come on automatically until you adjust your seat belt pretenioner in a way that the sensors read your seat belt to be safely set. naturally, if someone else drives the car he or she might have to readjust the seat belt pretensioner for the sensors to read them as being safely put. do this and the airbag warning light should go out.

Nov 13, 2008 | 1997 Hyundai Accent

Not finding what you are looking for?
1999 Lincoln Town Car Logo

Related Topics:

899 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...