Question about 2001 Dodge Durango

1 Answer

Radiator and Coooling assembly

I have a 2001 Durango that was in an accident. I am trying to install the new radiator and need a diagram of how the front end goes back together.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Dodge Master
  • 1,779 Answers

Check out this website, enter vehicle info, click on radiator support, they have some good diagrams that will hopefully help u. let me know if this is what u need . www.moparonelcom/partsmoc.htm countrycurt0

Posted on Oct 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change radiator 2000 dodge durango


It's actually pretty easy.
Here you go:
remove fan
remove fan shroud
open petcock and drain fluid (bottom corner of tank on engine side)
remove upper and lower hoses
remove tranny coolant lines
unbolt radiator and lift out. Reverse these steps to install the new one. Hope this helps.

Jul 15, 2014 | 2001 Dodge Durango

1 Answer

Coooling system blowing radiator hoses off or too much preassure


You have a Blown Head Gasket that is pushing Compression from your Cylinders into the Cooling System. That is the only thing that could be doing this if the hoses are installed properly.

Jul 08, 2014 | 1993 Jeep Grand Wagoneer

1 Answer

Installing radiator


1 - Upper seal board
2 - Radiator reservoir hose
3 - Radiator reservoir
4 - Fan motor connector
5 - Cooling fan assembly
6 - Condenser fan assembly
7 - Oil cooler hose
8 - Radiator hose
9 - Radiator bracket
10 - Radiator

23901254-cld1w30nam4pvdfzfn10ykwq-4-0.jpg Car Parts Diagram

Mar 24, 2014 | 1998 Mazda Millenia

3 Answers

My durango is leading water from the radiator cap


Check to make sure the cap is turned all the way closed.
After it cools down take off the cap and inspect the bottom of the cap.
If it doesn't look right, go buy a new one, its good insurance

Oct 08, 2010 | 2001 Dodge Durango

1 Answer

Replace radiator in dodge durando 2001


If you know for a fact it's the radiator, then replace it. If it's leaking, has been damaged in an accident etc. If there are no visible leaks, replace the thermostat and thermostat housing gasket first. If it still overheats, or is losing water, check and if necessary repalce the water pump. If the water pump is good, then check the heater core (should be under the dash inside on the passenger side) and you may need to remove some things (heater vents) to get to it. If this is not the problem, then drain the radiator and block, and put the new radiator in.

If you are overheating, and all cooling systems are good, and you are losing water then you may have a blown headgasket. Do Not drive the vehicle. Have the head(s) and block checked thoroughly for cracks and have the head gaskets replace (both of them).

Check the oil and if it has a milky look to it, (white/greyish color) then you have a blown head gasket.

Thank you,

carandcomps

Mar 26, 2010 | 2001 Dodge Durango

1 Answer

How to disconnect power to radiator fan


You have located the fan i take it, just follow the wire harness from the radiator fan assemble to the chaise. There's going to ba clip along the wire harness that can be un clipped and you can run a hot wire from the battery to the wire harness or you can test the wire harness from the chaises with a volt meter for power. You may also want to check the fuse and relays under the hood in the fuse box close to the battery. Good luck and hope this helps, Keep me posted, be glad to help.

Jun 18, 2009 | 2001 Dodge Durango

3 Answers

Lower section of upper radiator hose seperated from filler cap ho


yes, you are right! do this! the thermo costs between 3-6 dollars9100f2e.gif

Apr 26, 2009 | 2000 Dodge Durango

1 Answer

THEROMSTAT/ 2002 DODGE DURANGO???


make sure engine is cool then drain coolant by opening the drain plug at bottom of radiator. remove cap from radiator so coolant will continue to drain and when coolant is down enough to pull off upper radiator hose at intake then close drain, then remove two bolts at coolant housing and remove thermostate. clean gasket material from intake and housing and replace with new gasket and thermostate tighten bolts install hose fill rad with coolant water mix 50/50 and run engine with heat on floor until gets hot and you see coolant flowing in rad, install cap

Jan 17, 2009 | 2001 Dodge Durango

Not finding what you are looking for?
2001 Dodge Durango Logo

Related Topics:

226 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...