- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
This is going to sound a little odd, but properly jack the car and then try opening this door. Put the jack in the recommended jacking spot on the passenger side.
Imagine that the back and front ends of the car are compressing the center of the car. By lifting one end or the other, the center may shift. Otherwise you do not have a frame, but the engine cradle may have a support located closer to the center of the vehicle. Do not jack the sheet metal, but you may catch the cradle and apply lift there.
You may notice by putting in a piece of cardboard in the doorjam on whether there is an increasing gap as you jack the car.
There are two black knobs in the trunk. Near the top of the trunk. You have to pul each of those knobs first, then go back into the backseat and pull the seat down from the shoulder, not the head rest.
Okay so im just going to start from the seat being upright in a normal riding position.
1. You need to fold the head rests first. Pull the black tab under both headrests. They should spring into a folded position.
2. pull the side seat lever (on the door side of the seat). This will fold the top/back support down to an angle.
3. There is one more lever on the backside of this seat. Its in plain sight on the angled portion of your seat. Lift the big plastic lever.
4. While keeping the handle lifted, grasp the back of the seat and pull it torwards the front of the car. The seat should come unlocked and roll forward and down more towards the floor. If you have a bunch of junk on the floor, it obviously wont work. clear the path and the seat will fold completely flat.
Also, your drivers seat and front passenger seat cannot be all the way back, they need to come forward some in order for the second row seats' head rests to clear and fold flat.
(The engineers couldn't have hid these much better if they tried...)
1) Open the trunk lid all the way. 2) Look up under the inside top edge of the trunk opening. 3) You will see two 1" wide x 1/2" thick, black plastic knobs, about 1' apart from each other. 4) Pull straight back on a knob to release one of the back seat halves. 5) Go forward to the back seat compartment and lay each released seat the rest of the way down. 6) Paint the buttons white so the next person can find them easier!
There should be a loop between the seat and backrest, pull that and the seat will pull toward the front seats. After that, pull the lever located at the outside of the backrest. This lever is on the outside of the seat by the door-side of the seat. Pull that up and allow the backrest will fold down and the headrest will pivot back and your seat is folded down.