How do I replace the outside handle on my 1999 Sebring?

Remove the inner door panel & replace the handle

Dealer parts counter or salvage yard

your linkage rod to the outside door handle has disconnected , if you open up the door panel to access the lock linkage rods you will find the rod that is disconnected . There is a plastic bushing the rod is secured with if it is broken you must replace it , if the rod will not stay in place replace the bushing , hope this helps you out

just a piece of plastic its the only sensor it is located under harmonic balancer pully on most vehicles some are just right outside the harmonic balancer pully


if it helps please leave a good review thumbs up

Go to this link for detailed info on replacing blower motor resistor for '02 Sebring ... part looks different for the '99, but instructions are the same.
http://www.automotivehelper.com/topic294308.htm

what engine? I would refer you to a repair shop this is not a job you can handle.

take off door panels and get your hand inside. philips head and 8mm socket

in most vehicles, replacing the handle entails removing the inside of the door to access the mechanisms inside. there usually isn't a way around this. a repair manual can assist with directions on how to go about doing this type of project.

The repair will require removal of the door panel and adjustment/replacement of the rod that connects the outside handle to the lock mechanism, or replacement of the handle itself.

Replace the inner door handle. the dealer will have it in stock, just tell him the interior color. Real Common.

chrysler has a TSB on this issue. but for now you will need to replace the starter. But first you should get it diagnosed to be sure