Question about 2001 Toyota 4Runner

1 Answer

Power antenna how do you disconnect power to the antenna

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 1,861 Answers

Actually, there are 5 power feeds going into the power antenna control relay. If I am to assume that you just no longer want it to run, just remove the radio and disconnect the BLACK with a WHITE trace wire at the plug going into the back of the radio unit.

Posted on Oct 02, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I installed a new radio, everything works except the power antenna??


does the power antenna sense the power lead of the radio . Did you somehow disconnect a sensor wire from the radio power wire when installing the new radio.
This might be the cause of the power antenna not going up when radio switched on ?

May 03, 2015 | Cars & Trucks

1 Answer

Antenna motor keeps running. How do I disconnect?


2 ways you can do it> 1 find the fuse and pull it out but only if it is for the antenna or you can disconnect the antenna wire from the back of your radio, it is normaly a blue wire run with the power harness. Red is 12V. Black is Ground 0V. Yellow is Remote, it works with an AMP if you have one installed. Blue is normaly the power antenna. hope this helps> test it first by pulling the fuse to the radio and if the antenna does not operate then the power is from the radio

Jan 17, 2013 | 1985 Oldsmobile 98

1 Answer

Fuse location for antenna and radio


to stop power antenna from running,disconnect body harness from ant relay asm. 3 wire connector pink/red/black will disconnect from relay. if antenna continues to run and won't retract,the cord inside is broken. dealer item only or used.

Sep 29, 2011 | 1995 Buick Riviera

2 Answers

Power antenna motor won't stop running. Do you know where the cutout switch is located?


There is no switch. When the plastic gears inside the power antenna strip out they continue to run because the limiter switch inside the unit never gets tripped. If you can assist the antenna up when it's running, leave it up and disconnect the power to the motor. If i remember correctly the antenna is mounted on the passenger rear quarter panel. You should be able to pull some of the truck trim out a little and disconnect the two or three wire connector.

Jul 08, 2010 | 1993 Buick LeSabre

1 Answer

How do I install the power antenna? I have a replacement, and the wiring is there, but I don't see how to mount the part.


PLEASE DON'T FORGET TO RATE!!!!

Removal & Installation
  1. Lower the antenna and remove the luggage compartment trim panel.
  2. Disconnect the lead-in cable from the antenna and ground strap.
  3. Disconnect the antenna motor wires at the connectors and disconnect the control box connectors.
  4. Remove the top mounting nut and stanchion assembly.
  5. Remove the two nuts retaining the antenna bracket assembly to the quarter panel.
  6. Remove the antenna assembly from the vehicle.
8617042.gif
Some antennas require a special socket to remove the locknut

6210b68.gif
Once its loose the nut can be removed by hand. Sometimes it can be twisted off with a needle nose pliers, but that usually ruins the tool

afa5165.gif
The antenna mounts in the luggage compartment against the support member

abce961.gif
The motor and housing sit on a stand that is bolted to the support member

0ee099b.gif
Unplug the antenna lead from the staff tube

9b0f741.gif
Unplug the connector to the motor

fb68086.gif
Unplug the connector to the relay

d275fd1.gif
Its easier to remove the antennae from the support to gain access to the ground strap screws

To install:
NOTE Correct sequencing for installation is important to prevent water leakage or dimpling of the quarter panel

  1. Connect the antenna cable, power connector and control box connector.
  2. Insert the antenna mast through the quarter panel hole and position bracket on mounting studs in the luggage compartment.
  3. Install the stanchion assembly.
  4. Loosely install the two bracket retaining nuts.
  5. Install the top-mounting nut.
  6. Tighten the bracket retaining nuts.
  7. Install the ground strap.

Nov 19, 2009 | 1990 Lincoln Continental

1 Answer

How can I disconnect the power antenna from my 2001 toyota 4 runner?


Does it keep running all the time and you just want it to stay up. They"re not that hard to replace.
The radio power triggers the antenna and the ant motor can be disconnected in the pass wheel well.

Jul 02, 2009 | 1995 Toyota 4Runner

1 Answer

The motor on my power antenna for my 92 Olds Ciera won't shut off, is it possible to cut the power to the antenna and still use the radio?


Remove the glove box. Behind it will be the power connector to the power antenna. Disconnect it and problem solved.

Mar 04, 2009 | 1989 Oldsmobile Cutlass Ciera

2 Answers

Power antenna. 1986 olds delta 88


Obviously if fuse panel has a power antennae fuse, simply pull it, otherwise you may have to get to connector at motor by removing part or all of sheild in wheel well to access it in some cases. Only other option would be to remove radio from dash & disconnect antennae power wire from radio. Don't forget you want it up before disconnecting if you can.

Jan 30, 2009 | 1986 Oldsmobile Delta 88

1 Answer

POWER ANTENNA NOISE


you can cut power to it by disconnecting the plug where particulary is it located? on the vehicle i will be able to tell you how to gain access to it.

Sep 01, 2008 | 1992 Toyota 4Runner

Not finding what you are looking for?
2001 Toyota 4Runner Logo

Related Topics:

389 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...