Question about 2008 Ford Mustang

1 Answer

Clutch Cobra GT 500

Less than 19K miles. CAR IS NOT RACED, on the street or the track. Clutch is burned out and must be replaced. What caused this clutch failure?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 60 Answers

If for some reason the clutch was originally not installed properly, it could cause the clutch to go out a lot sooner than it should have.
Do you ever smell a funny "clutch" smell when you drive the car or after you park it?
Did anyone else drive the car besides you?
Did you leave it anywhere for maintenance or service?

Posted on Mar 13, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I stop the at the robot and the car did not want to go into first gear (Manual). After a few min of battling pushing clutch pedal it finally went in and I could drive again. What would the cause be?

It could be you are having a master cylinder or slave cylinder problem or maybe the syncro on the 1st gear got jammed for a few minutes. If it was a one time thing, I wouldn't worry about it. If it starts happening more often then you may be looking at a whole new clutch assembly. Honestly a good driver can make a clutch last a minimum of 150,000 miles assuming all mechanicals are good. If you've raced the car, did burnouts, dumped the clutch a lot, and or just generally drove the car hard, then you're about due for a whole new assembly and probably a tranny fluid change too, if you've never done that.

If you can't do these services yourself, I'd say get it to a trusted mechanic. You'll probably be looking at about $1000 - $1500 for the repair.

Feb 12, 2016 | 2007 Nissan X-Trail 2.2D

1 Answer

My 2013 Silverado auto trans (4.8, I think) is now idling between 500-1000 RPM. Had the truck about 5 weeks. Bought it with about 19K miles. Help please/ or suggestions.

Not enough info.. is the engine Throttling?? up down up down?? Idle should be say between a "Steady" 600 to 725 RPM.. depending if in drive or not.. BCB..

Oct 21, 2013 | 2003 Chevrolet Silverado 1500

1 Answer

I have a 1994 Chevy C1500 w/ 4.3 liter and my plugs are fouling out about every 500 miles or less and everything else maintanence wise I've replaced resently. Can someone give an idea on what need

Does the truck run right? Does it smell real gassy, fuel mileage go south? If it is fouling plugs that fast it either has to be burning a lot of fuel or oil. Is there a check engine light on? Engine wore out, burning a lot of oil. Fuel injector stuck, using a lot of gas. Air filter dirty, making it burn way rich. I would think this truck would really smell bad if it is fouling out the plugs that fast.

Jan 21, 2012 | 1995 Chevrolet C1500

2 Answers

How much oil usage is normal?

1 quart every 2000 miles. Not all cars are created equal. The same model may burn alot less or even more.

Apr 18, 2010 | 2003 Ford Escape

1 Answer

Clutch slipping or hydraulic system failure AGAIN.

no the problem is the driver ,riding the clutch and resting the foot on it whilst driving ,causing excessive wear and tear ,i would respectfully suggest you buy a vehicle with automatic transmission

Apr 16, 2010 | Hyundai Motor 2003 Elantra

1 Answer

Premature tire failure on 2007 Lexus GX 470

I don't know what 'cupping' is. If you mean wear, then it is probably down to having incorrect tracking set on the car. Go to a garage and get the toe out checked. If your tracking is out, you will wear the edge of the tyres. Over inflation will cause the centre of the tyre to wear, and under inflation will cause the outer and inner band of the tread to wear.
The vibration may be caused by the loss of wheel weights. Maybe knocked off by hitting a kerb which also may be the cause of the tracking being out. Driving over a deep pot hole in the road can have the same effect.

Aug 15, 2009 | 2008 Lexus GX 470

1 Answer

Roar in front end

I have the same thing. It started last summer when I had about 20,000 miles. I just took it into the dealer. They say it is the antenna and that they removed it and tested drove it and the noise went away. Mine starts around 35 mph. I don't know if they are pulling my leg and there is a bigger problem that the financially strapped GM won't fix. I also have a bad CV joint and unless it goes out within the next 500 miles, GM won't replace it.

Jan 19, 2009 | 2007 Chevrolet HHR Special Edition

2 Answers

Cobra GT 500 Clutch

Not totally disengaging, not properly installed, poorly aligned shift fork. What makes you feel its "burned out"? once taken apart the condtion of the clutch will indicate with wear patterns what truly happened. "riding" the clutch would also do so.

Oct 01, 2008 | 2008 Ford Mustang

1 Answer

Ford mustang acting like its not getting fuel

Sounds like a bad clutch to me. Get a new clutch installed and drive easy for the first 500 miles until it breaks in.

Jul 11, 2008 | 1999 Ford Mustang Cobra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5613 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides