Question about 1999 Chevrolet Malibu

1 Answer

Ignition wires Im a low voltage grad, but cars? I have to get my 5 yr old in 1/2 hr & car wont start,I saw a spark while cleaning area

Posted by on

  • yadayada
    yadayada May 11, 2010

    I have no idea what your question is

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 151 Answers

I'm assuming u had to bring ur 5 year old somewhere within 30 minutes and ur car wouldn't start and the spark is when u cleaned the engine with water huh?

If so, replace the ignition wires.
Do them one by one so as not to get them wrong.
good luck.

Posted on Nov 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Pls help me figure out what this code is so I can fix my car pls. p1305


- Ignition Coil No. 2 harness is open or shorted
- Ignition Coil No. 2 circuit poor electrical connection
- Faulty Ignition Coil No. 2
- Faulty Engine Control Module (ECM)

the likelyhood is that your coil pack has started to break or is leaking in damp
spray it with wd40

Dec 08, 2014 | Toyota Cars & Trucks

Tip

How to Test Spark Plugs in Audi A6 car?


1) Test the spark plug ignition. For that disconnect the spark plug wire from the spark plug.
2) Then touch the spark plug wire close to a metal surface of the car. Then spin the key in ignition switch. If you will see a spark or hear a crackling noise. This means the wire to the spark plug has voltage in it.
3) If there is no spark when you crack the engine it means that a spark plug wire is dead.
4) Check out all the battery cable, ignition wires and coil wires are hooked up properly to their points.
5) If any of the battery cable, ignition wires and coil wires is loose then this can also relate to no spark.
6) But if all the battery cable, ignition wires and coil wires are properly connected then its time to replace the spark plugs.
7) Before replacing clean the old spark plugs connections and recheck.
8) Many a time’s cleaning or moving the spark plug connections makes it work.
9) If nothing is getting the spark plug to spark, then it needs replacement.
This will help. Thanks.

on Mar 15, 2010 | Audi A6 Cars & Trucks

Tip

How to Test Spark Plugs in car?


The procedure is as follows:--
1)Test the spark plug ignition. For that disconnect the spark plug wire from the spark plug.
2)Then touch the spark plug wire close to a metal surface of the car. Then spin the key in ignition switch. If you will see a spark or hear a crackling noise. This means the wire to the spark plug has voltage in it.
3)If there is no spark when you crack the engine it means that a spark plug wire is dead.
4)Check out all the battery cable, ignition wires and coil wires are hooked up properly to their points.
5)If any of the battery cable, ignition wires and coil wires is loose then this can also relate to no spark.
6)But if all the battery cable, ignition wires and coil wires are properly connected then its time to replace the spark plugs.
7)Before replacing clean the old spark plugs connections and recheck.
8)Many a time’s cleaning or moving the spark plug connections makes it work.
9)If nothing is getting the spark plug to spark, then it needs replacement.
This will help. Thanks.

on Mar 15, 2010 | Audi A4 Cars & Trucks

1 Answer

1983 Capri RS WONT START it is getting spark to the plugs and fuel turns over fine just wont start


Points or electronic ignition? Corroborator, or fuel injection? Was the car sitting idol for a long period of time, say, 6 months to more than 1 year? With a car that old, I would start with replacing spark plug and ignition wiring. Have you checked the spark plugs? Make sure they're cleaned and gaped. If corroded, replace them.

Sep 22, 2014 | Cars & Trucks

1 Answer

Change spark plug wires 1998 acura tl 2-5 it wont start


you didnt change them 1 by 1, did you. oops...
see the FSM for this, by engine type
or alldata.com
this engine?
2.5L (G25A4) Engine Firing order: 1-2-4-5-3 Distributorless ignition system

front of car.
engine
coil pak( 4,5,C.3,2,1)
rear fire wall

Jan 28, 2014 | 1998 Acura TL

Tip

How to Test Spark Plugs in Audi car?


The procedure is as follows:--
1) Test the spark plug ignition. For that disconnect the spark plug wire from the spark plug.
2) Then touch the spark plug wire close to a metal surface of the car. Then spin the key in ignition switch. If you will see a spark or hear a crackling noise. This means the wire to the spark plug has voltage in it.
3) If there is no spark when you crack the engine it means that a spark plug wire is dead.
4) Check out all the battery cable, ignition wires and coil wires are hooked up properly to their points.
5) If any of the battery cable, ignition wires and coil wires is loose then this can also relate to no spark.
6) But if all the battery cable, ignition wires and coil wires are properly connected then its time to replace the spark plugs.
7) Before replacing clean the old spark plugs connections and recheck.
8) Many a time’s cleaning or moving the spark plug connections makes it work.
9) If nothing is getting the spark plug to spark, then it needs replacement.
This will help. Thanks.

on Mar 15, 2010 | Audi A3 Cars & Trucks

1 Answer

Car will crank there is no spark have replaced coil and condenser


Test the ignition system output, ignition systems can vary in configuration but operate on the same principal. Ignition systems can consist of a coil, pick up coil, crank angle sensor, cam angle sensor, spark plugs, spark plug wires, distributor cap, ignition rotor and a distributor and any variations of these components. An ignition coil is a voltage stepper coil that transforms a low voltage (12 volts) signal into tens of thousands of volts needed to jump the gap of the spark plug.

This coil is activated by an ignition module triggered by using the camshaft/crankshaft angle sensor; timing is adjusted by the PCM (computer).This primary electrical signal is generated by the PCM which calculates spark timing by using a variety of sensors including coolant temperature, mass air flow, and oxygen sensors. Go to 2carpros.com for a video on how to check this using a 12v light tool. On the engine repair section search, type, "engine cranks but will not start." If my answer helpe you, please leve good feedback. thanks

Nov 15, 2011 | 1992 Toyota Corolla

2 Answers

Car wont start: 1. Had it tested technician sad


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks

Jun 23, 2010 | Cars & Trucks

1 Answer

Firing Order diagram for 2006 Ford Explorer


Hope this helps. The ignition coil:
  • changes low-voltage pulses from the PCM to high-voltage pulses.
  • fires 2 spark plugs simultaneously.
  • has 3 transformers.
    • One transformer fires the spark plugs for cylinders 1 and 5
    • One transformer fires the spark plugs for cylinders 2 and 6
    • One transformer fires the spark plugs for cylinders 3 and 4
Spark plug wires:
  • carry high-voltage pulses from the ignition coil to the spark plugs.
The spark plugs:
  • change high-voltage pulses to spark at the gap, which ignites the fuel and air mixture.
The firing order is 1-4-2-5-3-6.

69efa96.jpg

Jun 06, 2010 | 2006 Ford Explorer

1 Answer

96 accord ex wont start


Firing sequence is off or plug wires are not connected completely. check the firing order, to the plugs and make sure all connections are on (you will have to push down on top of boot pretty hard to get a good connection)

If it is turing over jump starting isn't gonig to help (you battery if fine unless you have drained all the power from it)

Feb 02, 2009 | 1996 Honda Accord

Not finding what you are looking for?
1999 Chevrolet Malibu Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...