I have a Renualt Laguna rt sport 1998. There are four zeros flashing on the screen. I have the code,but none of the buttons respond when i try to enter them into the radio.is there a code for the code?!!!
I had a Laguna before the gearbox packed up. Nice car but a really bad gearbox. My radio was the same. What I used to do to get it going again was disconnect the battery and thereby power it down completely. After I reconnected the battery it allowed me to reenter the code as described in the radio manual.
Happy listening, with the radio on you wont hear the gearbox tearing itself to pieces.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
have you got the code? it will be printed on a sticker in your service books, normally inside the front page. enter the first number by pressing 1 on the radio until you get to the number you want. repeat the process using the number 2 button for the second and so on. once you've entered the four digits hold the number 6 button for about 3 seconds. the radio should beep and then you should have music.
the pins on the lazer bulb in your keyfob has snapped off caused buy pressing the button too hard. (the red light will still come on but the key wont work)
heres what to do
open your keyfob and pull the lazer bulbs pins to the other side of the chip board. solder it to the wrong side where you see the nipples (dont worry there still in the right place) and shove a bit of bog roll in there to stop the chip board moveing when you press the button
===================================Philips Renault Code Entry
Turn on the radio and the display will show 'CODE'
Use the steering controls for code entry.
Press the [ ¬] button then rotate the thumb wheel for the correct first digit Press the [¬ ] button then rotate the thumb wheel for the correct second digit Press the [ ¬] button then rotate the thumb wheel for the correct third digit Press the [ ] button then rotate the thumb wheel for the correct fourth digit
If the correct code is now shown on screen, press and hold the [¬ ] button for up to 10 seconds to store the code ===================================
numbers appear above the radio in the whatever you call it ,if memory serves me well its complicated like button for wave change to start process the one button does all four numbers number one button on the preset then change numbers with wavechange or volume control .honestly cant remember sorry